Post economical windshield replacements here!!!

[Sarge707]

https://www.revzilla.com/motorcycle/...SABEgLxK_D_BwE
The stock windshield is OK BUT since you have 4 bolts and adjustability I am only going to replace the shield and NOT the hardware.
It can be done. The stock is about 12 inches at the bottom and ONLY 8 inches on top SO you get a lot of passing side wind.
This one is Not bulbous looking and is 16" at the bottom and 13" at the top which is a Big improvement that with a template you can bolt to the stock mount about midway up so you equalize the pressure on the mount and you can still adjust via the sliding bolt on the stock hardware. This is 18.5" tall so a small portion of the bottom may need a little trimming.

Can You find a Better simple bolt on economical (CHEAP) windshield from your past bikes. I,m not going to pay 2-3 hundred?

[Tslepebull]

This one is a few dollars more than what you posted but comes in several sizes matched to rider height and leg length.
https://www.ebay.com/itm/Calsci-Wind...NjcQ:rk:4:pf:0

[chris56]

I`m also looking for another "larger" shield (here in Europe) but it should fit to the curve of front of the Ryker - maybe I cut it in the way of the "glove-heater-box and the lower part should be taped (?) in black or so, if you know what I mean .. do you plan to fix it on the handle-bar ??

this is what we have here (also the MRA)

https://www.louis.de/artikel/puig-un...b950eb344d4a09


https://www.louis.de/artikel/mra-cus...d42ad1307a4743

[Sarge707]

This one is a few dollars more than what you posted but comes in several sizes matched to rider height and leg length.
https://www.ebay.com/itm/Calsci-Wind...NjcQ:rk:4:pf:0

I have had the Calsci on 2 Spyders and they were Great but this looks too Bulbous (Is That a word) To Me.
I really like the MRA Highway because I think it would be a big improvement without looking out of place.
With rubber washers on each side of the four attachment points it would be no problem installing the shield to the stock hardware.