Tri Axis Installation Instructions - Need copy

[zuni]

So I have been following the various videos and have the bike mostly disassembled (2017 RTS) and now i am to the point of removing the existing handlebars. Watching part 2 of Bobs' video and I had a question so I went to the box and NOTHING. No instructions. Anyone have a copy they could scan and send or snap pictures of? Not a great look for the bike by the way but I do get to do a lot of cleaning.

Fingers crossed,

CJ JAX

[JayBros]

Go to this link, http://instructions.brp.com/e-instruction.html#tab=1,
type in the PN of the bars and they will appear. Print 'em out. If that doesn't work PM me your e-mail address and I'll send you the pdf.

[zuni]

Go to this link, http://instructions.brp.com/e-instruction.html#tab=1,
type in the PN of the bars and they will appear. Print 'em out. If that doesn't work PM me your e-mail address and I'll send you the pdf.

You Sir are a gentleman and my hero! JayBros for the save. Thank you. I owe you a beer, scotch, coffee, your preference.

CJ JAX

[IdahoMtnSpyder]

Go to this link, http://instructions.brp.com/e-instruction.html#tab=1,
type in the PN of the bars and they will appear. Print 'em out. If that doesn't work PM me your e-mail address and I'll send you the pdf.

There is a tab there also to search by product name. Saves having to find a part # if you don't have it handy.

[IdahoMtnSpyder]

One caution, based on experience. One of the early steps is, "Remove the keyswitch cables and let them hang." Just below that you'll see where it shows two bolts being removed and discarded. Those two bolts screw into, or pass through (I don't remember which) a plate about 3/4" wide by 3" long. If you're not careful you can easily drop that plate down into the bowels of the Spyder and it can be a royal pain to find. I had to buy an inspection camera from Home Depot to search around until I found it.