-
Very Active Member
BRP Saddle Bags
DSCI0020.jpgDSCI0007.jpgDSCI0021.jpgDSCI0015.jpgDSCI0019.jpg
Not really a 'Step by Step', but here are some photos that should help clear up the poor BRP destructions.
A few things:
Make sure you are mounting the proper turn signal to the proper side. The pics should help.
You have pull on the turn signal wires while pushing them into the hole and then into the bar - you can only really fit one connector through at a time - kind of tricky - but pulling from the other end helps a ton - just had to pull a bit harder than I expected.
Hopefully the photos will help with the rest. PM me if you have any questions.
Last edited by Firefly; 03-12-2017 at 11:10 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|