-
rs-s brake failure
ok... two things going on. changed oil and filters . new front pads also. starts, runs but get brake failure message, and wont go into gear, forward or reverse, topped up brake fluid and bleed them. ifs there's an issue with brakes will the system stop the transmission [se5] from operating ?
thanks for any ideas.
-
Active Member
Originally Posted by spyderchris-nz
ok... two things going on. changed oil and filters . new front pads also. starts, runs but get brake failure message, and wont go into gear, forward or reverse, topped up brake fluid and bleed them. ifs there's an issue with brakes will the system stop the transmission [se5] from operating ?
thanks for any ideas.
Could you have damaged an abs sensor, or cable...?
Richard
* 2012 RS SE5 (hers)
* 2013 ST SM5 (mine)
Daughter RSS SE5 2014
Son in law RSS SM5 2013
P.S. 3 Kumho AST 225/50R15 and 1 Toyo Proxies 4 225/50R15 rear tires
2 sets of Kumho 175/55R15 front tires
1 set of Hankook V4
1 set of Canadian Tire General tire Evertrek RTX in 14" for the 2012 ...
-
mmm. dont know. have to check further. try to retrieve a fault code.
-
pulled up code C1282....low brake pressure detected, possible brake circuit leak, check hydraulic circuit for possible leak. had the message come up before sometimes then its cleared. might need to go to the shop.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|