j&s jack with spyder adapter, where to place to lift
got the adapter for the spyder for the j&s jack but no instructions and before lifting or attempting to lift can anyone give me an idea of the lifting points, thanks for any help
As with any jack you are going to have to find the balance spot. You will be able to tell if the spot is correct with just a few pumps of the jack, adjust as needed.
There is a tiny square/rectangular piece with rubber on it. IT goes int the square/rectangular indentation behind the flat center frame rail.
2015 an Am Spyder RT Limited
2013 Yamaha WR250R - Sold
2011 Can Am Spyder RT-S SE5 Limited - Sold
2011 Aspen Sentry Trailer
2003 BMW K1200LT - Sold
2007 Unigo Trailer - Sold
2001 BMW K1200LT - Sold
2001 Honda 750 NightHawk - sold
2015 RT Ltd , Canamspyderaccessories Brake pedal ext. Red
got the adapter for the spyder for the j&s jack but no instructions and before lifting or attempting to lift can anyone give me an idea of the lifting points, thanks for any help
Which Spyder do you have? J&S told me they don't make a jack for the F3..
Mine is an RT. Not sure what the difference is between the two bikes in regard ti the subframe configuration
2015 an Am Spyder RT Limited
2013 Yamaha WR250R - Sold
2011 Can Am Spyder RT-S SE5 Limited - Sold
2011 Aspen Sentry Trailer
2003 BMW K1200LT - Sold
2007 Unigo Trailer - Sold
2001 BMW K1200LT - Sold
2001 Honda 750 NightHawk - sold
2015 RT Ltd , Canamspyderaccessories Brake pedal ext. Red