-
Active Member
2016 RT Antena
My rubber grommet where the Antena goes through the trunk won' stay in is there a trick to keeping it in or how to do it. Thanks for any advice Michrick
-
Its not the best design in my book.
Line up the tabs and push in thats it.
After that try not touching it anymore or it keeps poping out
Or try contact adhesive if yoy want it to stay in place.
-
Very Active Member
I could find no way of getting it to stay. Honestly, it bugged me so much I replaced the antenna.
2017 RT-S
Bump Skid - Spyderpops
Wrap - Wrapmyspyder
swaybar - Bajaron
Sena 20D & SM10
3 PC Mesh Zippered Lid Net Set - TricLED
A arm LED's - Safety LED's - TricLED
Mirror Sequential turn signals
Glo-riders
LED rear turn signals and reverse lights
Front Grills
Third Brake light
Larson Scanner
Light Up - Sue Hopper
-
I just removed it and replaced with shorty antenna just to plug up the hole. It's pretty useless anyway, in my opinion.
2014 RTL Platinum
-
Very Active Member
make sure you have the taper/bevel the right way. It's designed to sit square to the angle of the tupperware. Other than that....it's just a silly design
2021 RT Limited
-
First, make sure that your antenna is not loose.
Then put some silicone spray around the bottom of the boot so that it will slip into the hole all the way.
Push down and twist side to side slightly.......while lined up matching the slope of the body as mentioned above.
-
Very Active Member
The rubber pops out every time i put the cover on . What are some of you using to replace the not so good antenna .
-
Originally Posted by michrick
My rubber grommet where the Antena goes through the trunk won' stay in is there a trick to keeping it in or how to do it. Thanks for any advice Michrick
I used a little trim cement to glue it in no problems since.
Gary
-
Active Member
Thanks everyone for your comments. On this issue
Shorty antennas do they have a boot that covers
The hole up like the OEM boot
-
Very Active Member
My shortie antenna is from value accessories. It comes with a nice rubber piece that covers the hole.
2017 RT-S
Bump Skid - Spyderpops
Wrap - Wrapmyspyder
swaybar - Bajaron
Sena 20D & SM10
3 PC Mesh Zippered Lid Net Set - TricLED
A arm LED's - Safety LED's - TricLED
Mirror Sequential turn signals
Glo-riders
LED rear turn signals and reverse lights
Front Grills
Third Brake light
Larson Scanner
Light Up - Sue Hopper
-
Active Member
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|