-
Registered Users
-
Do just the controls move or the whole bar twist? If the bar moves there is a set screw that goes into the bottom bracket that should keep the riser bar from twisting once the bracket screws are tightened.
-
Registered Users
Originally Posted by Trickie Dick
Do just the controls move or the whole bar twist? If the bar moves there is a set screw that goes into the bottom bracket that should keep the riser bar from twisting once the bracket screws are tightened.
No. The bars are tight. Just the controls move about a 1/4" What is the magic fix???
Steve
-
Very Active Member
The glass is half full.
Mike Murphy
Happy Spyder Owner
-
-
SpyderLovers Founder
Is the locator pin in the plastic still there? I know that I've seen some new Spyders with that pin missing.
-
Registered Users
Originally Posted by Lamonster
Is the locator pin in the plastic still there? I know that I've seen some new Spyders with that pin missing.
I've taken lots of controls off in my days of working on the many bikes I've owned. First thing I did when removing each control, was slowly open it and look at what is inside. Looking for a something that would fit into that notch. Nothing. Thanks for the heads up on the pin. I'm going to losing it up and slip a peace of rubber an tighten it down, that should work.
Steve
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|