So, I read in post on here that the grease fittings on the front upper and lower A-arms are hard to get to and may need special fittings on the grease gun. To make a long story short, I have two of the recommended fittings ready to go on my grease gun but... I can't find the cock-a-doodie-grease fittings! I'm looking on the short tubes that run relatively longitudinally with the center of the bike axis that are welded to the end of the each of the "A"-arm. I have even used a mirror thinking that maybe it's directly behind it in a spot that I am certain is impossible to access regardless of the gun's fittings! I can't find ANY grease fittings on any front suspension moving parts. I looked at the shop manual I have and it shows them to be exactly were I expected to find them but... they aren't there. Can anyone shed some light (or perhaps a picture??) on where the fittings are? Is it possible some of them did not have inner a-arm grease fittings at all?

Thanks in advance!