-
Active Member
Where should I tap into to get switched power for the FZ-1 Fuzeblock?
I installed the fuze block on the right side behind the panel, just below the right mirror. I ran the constant power and ground lines straight to the battery. Works great. Where should I run the switched line to? I don't want to upset the can bus system.
-
Active Member
Used used this
Hi when I did mine I tapped into the switched wire for the gas gauge as the gauge was no longer there. It works great!
14 RT-S , Stock Large brake pedal White Pearl
-
Active Member
I still have my gages there, but people say the digital display is more accurate, so I might disconnect them. Until I do, would it mess anything up to tie into the switched positive on either the temp or fuel gage?
Forum
RT Shop Talk
Where should I tap into to get switched power for the FZ-1 Fuzeblock?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|