-
F3T front grill removal
Anyone had a chance to remove the front grill in the F3T. I am thinking about doing some mods and thought it would be easier if the grill was removed. Hopefully it will be a few easily accessed screws and out it comes?
Buckskin
-
Very Active Member
I did it a while back to clean the radiators after we followed a hay wagon. I think it was 4 screws.
2016 F3 Limited
2019 Ryker Rally
2014 Suzuki V Strom 650
2020 CSC TT 250
-
That's what I was hoping. Will take a flashlight and look around for the fasteners and see if that gets them all.
Buckskin
Originally Posted by Highwayman2013
I did it a while back to clean the radiators after we followed a hay wagon. I think it was 4 screws.
-
Active Member
Yep. only 4 screws, and it is easy to get on and off, I have done it a few times, amazing how many bugs etc get in there.
I put some LEDs in there and they provide a subtle light through the grill, I was hoping to paint the mesh behind the grill
blue as well, but patience isn't my strongest virtue a lot of clips attached to plastic lugs to hold it on, I know for sure I
would break at least one hahaha
We now have His and Hers Spyders.
Current Spyder, 2015 F3 Steel Black, Passenger Backrest, Blue Ridge Screen with Xcreen Extention, Akrapovic Muffler, Attitude Handlebars, Blades front rims, RT Swaybar,
Her Spyder 2011 Magnesium RSS Sportrack and Backrest, Comfort Seat, Grip Puppies, 3.5 inch Riser Bars, Wespyd Signature Swaybar. Hindle Muffler, Godiva Screen, Hiway Pegs Can Am Panniers
Previous Spyders
2013 ST SM5
2011 RSS
2010 RS
-
Very Active Member
If you jack up the front about 7 inches you can sit in a armless office chair and remove them. The first time I was laying on the floor- Not great at 68?
The front fascia has 6 screws -4 in front and a push pin on bottom- 2 around the lower back sides that are a pain to get to?
2015 F3 sm6, Custom Dynamics fender lights.
Sea Doo GTI-SE 90 Jet Ski!!
-
Active Member
Very easy, I removed mine at the 3000 mile service to clean and hose the radiators out. Was very clean, not bad all.
-
Very Active Member
-
Very Active Member
Ano wrench here
It was so easy I could do it........and put it back on!
White 2013 Spyder RT Limited. BajaRon Swaybar, Custom Dynamic Third Brake Light. Ultimate Custom Black and White seat with driver and passenger back rest. Gloryder Led Wheel lights.Custom Dynamics Led Bright sides, Amber and Red Fender lights, and Saddle Bag Bright sides.
2016 F3 Limited Intense Red Pearl. Lidlox, BRP Driver Back Rest, BRP Passenger Back Rest,Fog Lights, GPS, Signature Light! Custom Dynamics LED Bright Sides, Amber and Red Fender lights, and Saddle Bag Bright Sides.
-
Very nice Doc! Mines a '16 F3T, but most likely it's the same.
Buckskin
Originally Posted by Doc Humphreys
-
Very Active Member
I really like the new setup. Since the radiators are turned sideways they don't pick up as much stuff from the road and are easier to blow through with compressed air from the outside with the grill off. Good bit of engineering there, BRP!
-
MOgang Member & Pyro-Man
F3T Grill Won't fit back into the body tabs
The grill comes off real easy. I put some LED lighting in the back of that area and I cannot get the grill top tabs into those 4 body panel slots to save my life. The screw holes line up just fine. But, with the tabs not in the slots there is a ton of light leakage coming through the top of the grill and the body panel. Has anyone else had this issue? Ive been working on putting this back together for the last few hours. I'm at a loss.
“Dream as if you'll live forever, live as if you'll die tomorrow.”
―James Dean
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|