Search:

Accessories are normally developed after the production vehicle has been confirmed so these parts are normally delayed as suppliers need lead time and engineering also needs time to develop but the...

if he is a regional rep, isn't he just a sales guy, they don't have technical road reps, they can do features and benefits but aren't that technical

It is definitely warranty, have your dealer call the BRP tech line for a I am 100% sure.

they just started getting the seats into stock in small numbers and should start shipping next week. I have one on order too, a gift for my parents 51st anniversary, I spoke with someone who had...

They do this to make it more appealing to the people outside the `TARGETED`range. People think that if it is marketed for that type and age group, that they can ride one too, it makes them feel...

The Aprilia sportbike it came from can rev but has 6th gear also. I find the Spyder easier to back up than a motorcycle so i would give up reverse for the sixth gear but this might create harmonics...

I checked, they are currrently in stockat BRP, part number 219400175

Its supposed to help dissipate the heat from the sparkplug

If you could find a ratio where you make the front larger and the rear smaller, you could use the same belt. I am sure there would be a few people interested in a kit like that.

I was at a stop light where it had just turned green. the gus in the car in front of me were checking out the girl on the sidewalk so I gave them a polite beep of the horn. They turned around and...

What parts are they waiting for to repair?

Looks awesome, I think BRP would think the same as long as you aren't out somewhere commiting road rage. Who can refuse free advertising. They would have to start paying everyone on the site for...

must have been on the starter solenoid, the live side of the high tension wire, at the starter there is no current flow until you hit the start stop button and the solenoid engages. You have a great...

its normal,helps build oil pressure with dry sump engine especially for SE5,

The centrifugal clutch has small rollers that look like dumbells. As the rpm's increase the rollers move outwards and spread the centrifugal outwards and applies pressure on the clutch pack which is...

check that all updates are done, if there are any and then add super unleaded to the remaining fuel to balance out the octane and the other fluids aren't 2 yrs old yet so they should be fine other...

50/50 mix any aluminum compatible which is just about all of them nowadays. Cars and trucks all have some aluminum components coolant circulates though. Brp sells pre mix because it just easier for...

Ask the dealer to perform the brake pressure pedal test when hooked to the computer, it should consistently be over 508 lbs every time you push it, mine is around 850 on the first try. i think you...

It should be warranty, they will not brake other than when adjusting if the front shocks are not unloaded. They are stressed differently when adjusting. I used to see them break quite a lot on the...

I cleaned up the look by drilling a 3/8 hole at the bottom of the front fender supports, at the top of the triangle shape and ran the wires through the support up under the fender to the running...

if it has not already been replaced, there is a warranty bulletin that has the dealer replace and reset. This should ne done under a campaign or under the normal warranty. It really needs to be reset...

it is better they do the bulletin complete from a-z the spring increases oil pressure to aid shifting and the gbps sensor reads more acurately and reduces electrical issues, the program also helps

on the front fenders, i drilled a hole at the bottom of the front fender support and ran the wires through the support, looks much cleaner

some read higher because the dealer did not relocate them as per the pdi bulletin. If it is located where it is before relocating at pdi, it is behind the trunk and close to the front exhaust pipe in...