JI put a nitto nt450 205/55/R15 on my bike ,the tire is the same diameter as the stock one. but this tire is V rated and a high performance tire ,the width is marginally narrower than stock. very...
Type: Posts; User: lchain
JI put a nitto nt450 205/55/R15 on my bike ,the tire is the same diameter as the stock one. but this tire is V rated and a high performance tire ,the width is marginally narrower than stock. very...
I put a Nitto NT450 on my bike and have another 5000 mi. on it, with little or no loss of tread depth. the size I went with was a 205/55/15VR that is a hi performance tire and the same diameter as...
I put a Nitto nt450 205/55/15 on the rear at 5600 mi. I now have over 9300 mi. on the bike with no real ware on the tire. I run 26psi to 28 and have good traction in wet and dry conditions. the tire...
the hitch it self is very easy to install , you attach the two side plates to the hitch bar and take the axel nut covers off the rear axel and slide the hitch into place. and the new long bolt goes...
I use a set of old car ramps on the front and a floor jack under the shock on the swing arm, gives plenty of room.
I may be to late but I put a nitto nt 450 205/55/15r on my new 14 rt and the speedo and rpm's match the kendas perfectly. good tire good on wet and dry roads. took about 600 mi. to brake in now even...
put more air in the tire, I started at 26 psi and adjust from there.
I may be to late but I put a nitto nt 450 205/55/15r on my new 14 rt and the speedo and rpm's match the kendas perfectly. good tire good on wet and dry roads. took about 600 mi. to brake in now even...
I may be to late but I put a nitto nt 450 205/55/15r on my new 14 rt and the speedo and rpm's match the kendas perfectly. good tire good on wet and dry roads. took about 600 mi. to brake in now even...
I went with a nitto nt450 205/55/15R/ V . works very good and speedo and R
PM's the same as with junk kenda tire.
first off I got a new tumbler with my bike. and second I can start my bike in gear with the foot brake on.good luck
I looked into this extensively and found that it says at 28000 mil. to change it, and my dealer agreed. and by the way it only cost 104.99 from can am.
If you take the bracket loose from the seat you can then put one small washer between the plate and upright that is bolted to it, very easy to do. the washers go on the front two allan head bolts....
If you take the bracket loose from the seat you can then put one small washer between the plate and upright that is bolted to it, very easy to do. the washers go on the front two allan head bolts....
by the way I ordered the seat today. I'll let you know how it feels after I install it.
I put highway pegs on and that helped some, then I took of the water wings so I can move my feet forward. that helped a lot. now I'm going to order the ultimate seat for the tall man, it moves you...