Search:

Type: Posts; User: Chupaca

Page 1 of 17 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    15
    Views
    277

    A lot with a little

    A lot of sad and bad with some good news too. :pray::pray:'s to both do miss Bob here...
  2. Thread: P0172 reflash

    by Chupaca
    Replies
    3
    Views
    130

    Interesting....🤔

    Must not be a big issue as they say Ryde on with lower octane fuel...:dontknow: on the old twins it usually just need to replace the vacuum hoses....
  3. Replies
    1
    Views
    68

    Ahhh yes...!!

    Those pesky little hoses to the throttle body. Silicone replacement is thevonlyvway to go cut to the same length. O2 is probably still good but also check the intake manifolds for same cracking as...
  4. Replies
    25
    Views
    482

    It is recommended that bolt NOT be reused as well...

    It is recommended that bolt NOT be reused as well as the washer. I replaced them as well as the flywheel weight bolts. They come with the loctite already on them...:thumbup:
  5. Replies
    25
    Views
    482

    Strange as it may seem... when I re-torqued it so...

    Strange as it may seem... when I re-torqued it so I could keep rydeing till the parts came in from Cheapcycleparts.com I could not go to the full recommended torque as I could feel it stretching or...
  6. Thread: SAE connector?

    by Chupaca
    Replies
    8
    Views
    151

    Well....

    not looking like any heated gear plugs I have been around but could be. I would think it is more likely a battery connection. If you can get to your battery you will see the connection...
  7. Replies
    8
    Views
    379

    HowTo: Not sure...

    you have a 2014 and I don't think they were still using the shutter system on your model. If you have a dual filament bulb you do not have the shutter system. Mine has a single filament H7 bulb so...
  8. Thread: 20-50 w oil

    by Chupaca
    Replies
    13
    Views
    264

    Once again....

    Comes up from time to time and as a rule of thumb if you are in a warmer climate 20/50w works fine. Now if you are fine with changing back and forth as you do have cold weather as well then do the...
  9. Replies
    25
    Views
    482

    Very similar...

    175099 175097 175100 175098 On mine the bolt streched and was loose, the sprocket would slide about drying the shaft and creating the rusting. You can see the end worn on the sprocket compared to the...
  10. Here's the thing..

    It would have to be proven that they were the cause of the incedent. Be it insurance or warranty and it could go to anything like oil, gas, filters, pads, plugs etc. Have not seen this happen during...
  11. Replies
    7
    Views
    181

    Well done....

    Always good to see the DIY project and how they work out. Should keep things clean in there for a good amount of miles more than stock....:2thumbs:
  12. Replies
    4
    Views
    152

    Agree...

    There will be an improvement as Ron has explained above. BRP has always been middle of the road on the bar so for many it is just fine as they do less than agressive ryding. You can go it step by...
  13. Replies
    6
    Views
    187

    For sure....

    dealer can hook up to buds and get you the codes and clear them as well. Strange that you would have the orange screen without a code or a warning light like , oil, brakes, VSS, DPS etc. Those...
  14. Replies
    6
    Views
    187

    For sure....

    dealer can hook up to buds and get you the codes and clear them as well. Strange that you would have the orange screen without a code or a warning light like , oil, brakes, VSS, DPS etc. Those...
  15. Replies
    10
    Views
    348

    Battery....

    You said the battery is 14 months old so I wonder what brand it is and is it the oem battery. There are some battery testers that plug into the cigarette lighter and will give you condition and...
  16. Replies
    7
    Views
    270

    Nice novelty.....

    Most understandable on semi's and transport vehicles. Many cars have them built in now to let you know when a tire is low. When they were introduced for the spyder there were issues and in the end...
  17. Replies
    6
    Views
    339

    as I see it....

    This would be a time lapse warning and not a condition warning. So should it come up you would have plenty of time to make an inspection and or change as needed. A lot will depend on the type of...
  18. Thread: Ryker Fun

    by Chupaca
    Replies
    14
    Views
    497

    Soooooo...!!

    Where was the fun part...?? :roflblack: hate to work in those conditions just sweat all over the work...One of those swamp cooler fans helps a lot....:thumbup:
  19. Thread: 2010 RT issues

    by Chupaca
    Replies
    7
    Views
    152

    Interesting....🤔

    As to the oil..... you can only get an accurate reading when the engine is at operating temp. Do not add any oil if you measure cold or you will have it coming out all over the place....The clusters...
  20. Replies
    8
    Views
    178

    Impressive....

    Gonna be hard on the old timers and young-ins.... I mean a Harley with no sound......:yikes::roflblack:
  21. ta🎶da....

    So that's it....you can now ryde on knowing that issue will not rear it's ugly head...:riding:
  22. Replies
    3
    Views
    1,233

    So I've heard...

    :agree: what he said but... we will see:spyder: you never know ...🤔
  23. Replies
    19
    Views
    569

    Sad News....

    Well to be honest it happens on all roads. I do ryde more causiously on farmland areas for that very reason. Too many feel they are just going down the road a mile or two so why tie things...
  24. Thread: RS Fan

    by Chupaca
    Replies
    25
    Views
    309

    keep going....

    I have an RS 2012 sm5 and the fan does not come on till I am well over the 5 bars which in the california heat is about normal. In cooler weather will run 4-5 and in cold weather here will run 3-4. I...
  25. Hang in there....

    Know you can do better and there are a ton from florida here that will get you the information and location to get the job done. Seems the labor and other add ons are good price if on the spyder...
  26. Replies
    7
    Views
    204

    congratulations....🎉🎉🎉

    exciting for sure...:clap: Just ryde and enjoy the whole getting to know your ryde. The farklling and mods will come once you find out what you are missing or feel you need. As most do safety first...
  27. Replies
    11
    Views
    276

    Here you go...

    Oceanside CA 1977 44,000 miles Leather and cloth seats "T" tops. Runs was in storage a long time....but good price...:thumbup:
    174955 $9,700.00
  28. Replies
    7
    Views
    124

    Sad News....

    Saw that yesterday...:pray:'s to all the family and firends. He left his print if you get the chance see it again...
  29. Oooh....

    Thanks for the detailed information. :bowdown: And yet another tire to add to the list. Let us know how it works out down the road ....:thumbup:
  30. Replies
    15
    Views
    432

    Interesting....🤔

    Good catch...:yikes: must have been a batch of undrilled axle bolts but does make you wonder why it was not caught in assembly....:dontknow: Worth a look F3 owners that have not been in that area as...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4