Search:

Type: Posts; User: Woodaddict

Page 1 of 17 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    15
    Views
    674

    start driving aggressively, that might cure the...

    start driving aggressively, that might cure the sleepiness :yes::clap::ohyea:
  2. Replies
    48
    Views
    948

    Poll: Been a webpage fan since March 2017 here. Just...

    Been a webpage fan since March 2017 here. Just joined the Facebook site about 1 yr. ago. There is more misinformation on the facebook site, than here. We have a lot of VERY knowledgeable members here...
  3. HiFlo 556

    HiFlo 556
  4. from the writing, and tire size you installed is...

    from the writing, and tire size you installed is 225 wide, most have used the 215 wide. so thats a bit wider, but will run IF the belt is moved away from flange. the right side adjuster will move the...
  5. check your front lug nuts to be sure they are...

    check your front lug nuts to be sure they are tight
  6. What is missing from instructions here is charge...

    What is missing from instructions here is charge with 1-2 amp charger for about 18 hrs. That is what my paperwork said (bought new just 1.5 weeks ago). That charger is considered a "slow" charger,...
  7. OR...... you forgot to put petcock back on "run"...

    OR...... you forgot to put petcock back on "run" after fill up and was left on "reserve" and when you went to switch it, motor was dead!!!
  8. I would say you missed part on the instructions....

    I would say you missed part on the instructions. Should use a 1 or 2 amp charger for 18 hrs or so. You had a bottle supplied with battery, that when bottle electrolyte is put in and cap pressed on,...
  9. Replies
    27
    Views
    1,121

    BATTERY!!!!!!!!!!!!!!!!! You're lucky to get...

    BATTERY!!!!!!!!!!!!!!!!! You're lucky to get back home. They have been installing cheap Chinese batteries for a while. Plus, maybe your dealership didn't properly charge battery on assembly. A 1 or...
  10. Did the pipe move when bumped with a hammer, like...

    Did the pipe move when bumped with a hammer, like just checking to see if WASN"T welded and would move? Too late now...

    My guess would see more of a separation/seam if not welded a little bit and...
  11. 1/4" is a bit too much. Spec is 1-5mm, which is...

    1/4" is a bit too much. Spec is 1-5mm, which is about 3/16"; as long a belt is not OFF the left side of pulley it will be OK. You could bring it in closer by adjusting the RIGHT side tensioner....
  12. yeah, common problem for new riders / owners. I...

    yeah, common problem for new riders / owners. I think tank is 6.9 gal. But you can insert spout fully at first until a click off, then barely have nozzle in, and a bunch of mini squeezes until gas...
  13. WE NEED AN LOL button, not just like and thanks...

    WE NEED AN LOL button, not just like and thanks for post!!!!!!!!!!!!!!!!!!!!!!
  14. all this good info and the poster has NOT been...

    all this good info and the poster has NOT been back on to review these comments. only made 1 thread and not been back since Jan 27th
  15. Congrats on a 2024 Spyder. They have been...

    Congrats on a 2024 Spyder. They have been installing a cheap chinese battery in these last few years. Probably just need to charge up better. The dealership maybe just didn't charge it up properly....
  16. Replies
    12
    Views
    709

    The shock is NOT meant to pop it right up from...

    The shock is NOT meant to pop it right up from the closed position. I have a rack on the back lid, and I can easily grab that and start the upward motion to go up, but I don't release it, I just...
  17. it might be fiberglass reinforced plastic

    it might be fiberglass reinforced plastic
  18. 1330cc, its bolted on engine for internal use....

    1330cc, its bolted on engine for internal use. the V Twin was external with a hose.
  19. there is NO oil tank, all oil in inside...

    there is NO oil tank, all oil in inside crankcase. However the V Twin 998 early models had an oil tank
  20. well, you have have one of those engines with...

    well, you have have one of those engines with porosity issues then. Take it to a dealer. At least one report of a new engine being swapped out on warranty. Hate to see you have a bad casting. BUT...
  21. there has been a couple of engines with porosity...

    there has been a couple of engines with porosity issues that has been reported here. Oil on the cable is severe overfill. It CAN come out the the fill tube. Maybe the dealer did NOT know and...
  22. Some riders have put them inside the frunk,...

    Some riders have put them inside the frunk, velcro-ed or double face taped to the upper side of the lid inside.
  23. Replies
    6
    Views
    476

    minor adjustment on date. I was...

    minor adjustment on date. I was there.............. from Mar 31 - April 2nd
  24. has the engine oil been OVERFILLED REPEATEDLY??...

    has the engine oil been OVERFILLED REPEATEDLY?? If you check the Spyder oil like your accustomed to do for an auto, then its wrong. It could be coming out the fill tube cause of an overfill...
  25. you found my answer to my future question!! I...

    you found my answer to my future question!! I didn't wire anything up to the accessories circuit yet, but was wondering if I needed to take bolts out of right fuse box and look at back in order to...
  26. Replies
    7
    Views
    797

    Could be smell from catalytic converter? The...

    Could be smell from catalytic converter? The clutch is inside engine running in oil whether semi auto or manual. How many miles?
  27. WELCOME TO SPYDERLOVERS.COM You came to the right...

    WELCOME TO SPYDERLOVERS.COM You came to the right place. Others have done this by using the cover and buying a Shad box is the cheapest way. If you search in the search box - upper right................
  28. Replies
    5
    Views
    499

    WTB: this is a whole lot better You don't have...

    this is a whole lot better



    You don't have to buy from Can Am. This is only your 2nd post, so you might not be aware that you can (& many of us do ;) ) buy from discount retailers instead of...
  29. if your dealership understands 2022 RT firmware...

    if your dealership understands 2022 RT firmware upgrade on spyder, go to them and have it done. not sure on firmware #, but if it has NOT been done there is an upgrade for it, might help the little...
  30. There is NO movement of RT oem floorboards. That...

    There is NO movement of RT oem floorboards. That slightly forward tilt is the best for comfort for most people. Trying to adjust them up or level would mess with the brake low limit floorboard...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4