Mine came with the wire for the low brow light BUT no light in the FRUNK.
Type: Posts; User: spyderryder53
Mine came with the wire for the low brow light BUT no light in the FRUNK.
I know this is an old thread but just wanted to say as you know MARKS SUCKS! He ripped me off twice, but I didn't notice it 'til the second time. I took my bike there twice for the 28k service and on...
I tried to put the spring on, but it doesn't work when I put the rear seat on. Is the spring supposed to go all the way down? And stick up past the shock body?
Nice trailer to bad you're 2200 miles away would probably be a big expense to ship.
I'm sure it will go quick. Good luck.
Thanks for the info but the 2022 is as it should be and I don't want to mess with that.
( that's above my skill set anyway lol )
I'd rather change the trailer to 4 pin
or look for a freedom...
I wish you were closer, does that have the 4 pin square plug?
There are amber bulbs in the signal and back up I'll have to dig it out and plug it in to see if the past owner converted the backup to signal lights
Thank you for your help much appreciated.
My signal lights are separate from the brake lights
The connector under the trailer is a 6 wire.
Thank you
I'll double check on the wires I could be mistaken, or it could be 6 wires and 1 not connected.
Right now, I have the 9 pin (6 used) on both my trailer and Spyder (2014) so I'm all set there, BUT I have a 2022 RTL with a 4 pin square plug and was wondering how to use the trailer with it?
Anyone know where l can purchase a plug and play harness to convert a 2010 RT622 TRAILER to a 4 pin square. Also the harness for the GROUND fix? TIA.
Thank you very much for the info.
I have a 2010 622 trailer with a 9 pin plug. I also have a 2014 RTS with the 9 pin plug. I have a 2022 RTL and would like to use the trailer with both bikes, is there an adapter from 9 pin to 4 pin...
Will do thanks
I was thinking the same about zip ties .I'll get screws and lock tite or pick up a rivet gun.
Thank you PMK
Has anyone replaced the BLS , with anything other than rivets like screws or zip ties?
Thanks in advance
Leon
Thanks I'll check that out
No, unplug it from where?
Just curious what fuses were blowing on yours? My compressor quit I didn't replace it but had my rear shock replaced with an elka2 and now I'm getting a C0040 code and my vcm fuse blows
Thanks ...
No I haven't checked it with a meter.
I did recently have the rear shock replaced.
I'll look for a bad wire I looked in the back but not under the pedal.
Thanks
Has anyone replaced a brake light switch and was it a big job?
I have a 2014 RTS and something keeps blowing the VCM fuse :banghead: I'm getting a C0040 code and C006C which mentions the light...
Will the air line from the Schrader valve reach the air bag or did you have to add to it?
Can you get to the air bag from the side panel removal or do you have to remove the trunk?
This will replace the air system completely
I ordered all 3 stage 2 shocks but with Clovis they are 3 to 4 weeks behind.
Mine went out too. I ordered 3 new stage 2 Ella shocks from Leominster garage but the factory is a few weeks behind on their orders.
Thanks for the help
Thanks Mikey I'll have to try that.
My rear shock isn't holding air, the pump was running a lot so I guess it burnt out.
I'm not sure if just the pump needs to be replaced or both shock and pump.
Has anyone disconnected the pump...
You were 100% correct I had it reversed, thanks