Search:

Type: Posts; User: JBnLIZ

Search: Search took 0.02 seconds.

  1. Replies
    52
    Views
    17,608

    Hi from NZ and in process of fitting y pipe with...

    Hi from NZ and in process of fitting y pipe with the PCV auto tune - I know it has been a while but do you still have the photos of where you welded the additional O2 sensor adapter in. (They are...
  2. Replies
    11
    Views
    1,714

    998cc: Thanks

    Thanks
  3. Replies
    11
    Views
    1,714

    998cc: Hi all have a 2011 RT The Y joint equivalent...

    Hi all have a 2011 RT
    The Y joint equivalent (OEM # 707600650) - aftermarket is the Honda OEM # 18392-MAM-000

    What I am looking for is the is the exhaust gasket - between muffler and headers OEM...
  4. Hi again all - can anyone tell me the draw amps...

    Hi again all - can anyone tell me the draw amps or watts for these either single bank or together. Cheers
  5. Hi: yep but using the negative wire (home made...

    Hi: yep but using the negative wire (home made plug n play) through an off relay.
    Power to the lights comes from the relayed fuse box, though another power relay. Using the negative side as the...
  6. Yes and no I had extra indicator LEDs on my...

    Yes and no I had extra indicator LEDs on my mirrors and this played up no end with my electronics- hyper flash/screen sensitivity. I removed 1 set and left a small set in place no probs.
    I have...
  7. Thanks this is what I have but wanting to know...

    Thanks this is what I have but wanting to know what the amp/watt draw is so I can match the correct fuse rating to the lights
  8. 2011 RT fender lights - what amps would strip LED's draw??

    Hi all. I am wanting to put the strip LED light to the fender but want to route via a separate accessory fuse block. What I am trying to ascertain is the amperage or watt being drawn so I can place a...
  9. Replies
    5
    Views
    1,661

    Thanks Dave. We have a couple of people in other...

    Thanks Dave. We have a couple of people in other parts of our country that use these and think they are ok. I was just looking to see if there was any draw backs from getting this set rather than the...
  10. Replies
    23
    Views
    5,004

    Hi has anyone got a picture of the rear tyre and...

    Hi has anyone got a picture of the rear tyre and tread, as this is what I want to replace and make sure they put the right one on. 2011 RT
  11. Replies
    37
    Views
    6,274

    Yep did the 3 magnet replace on 2011 RT but also...

    Yep did the 3 magnet replace on 2011 RT but also rigged up tethers quick release clips so covered all round if fall off. I did replace the analogue gauges though - right side with digital volt meter...
  12. Replies
    5
    Views
    1,661

    Sena SF4 or Cardo Freecom 4 plus

    Hi all from NZ.
    Info: wife and I use LS2 modular helmets with sun visor - because of this there is a need for slimline models that don't stick down below the edge of the helmet and stick to the...
  13. 2011 RT headlight and fog light led replacement

    Hi all.
    From NZ. Our lighting system on the bike is different from USA or Canada.
    headlight is full beam only and the fog light is used as the low beam.
    The headlight full beam is not the issue...
  14. Replies
    36
    Views
    5,209

    Hi all many thanks for the info and short cuts to...

    Hi all many thanks for the info and short cuts to view items. Lots to ponder.
    Cheers Dave
  15. Replies
    36
    Views
    5,209

    RT mirror backing removal

    Hi all..
    Has anyone done a video on how to remove the backing of an RT mirror. I want to put some turn signals on the inside edge of the mirror but very tentative about removing the outside backing...
  16. Replies
    6
    Views
    1,117

    Thanks all for the info most appreciated. Dave

    Thanks all for the info most appreciated. Dave
  17. Replies
    6
    Views
    1,117

    Thanks Mike will have a look. Dave

    Thanks Mike will have a look. Dave
  18. Replies
    6
    Views
    1,117

    Head light not on when running

    Hi all. I have a 2011 RT Ltd and the head light does not come on at all on low beam. The heigh beam an flash works on the left hand side handle bar. How do I get the low beam to work - the manual say...
  19. Replies
    9
    Views
    3,995

    Rt vent kit

    Hi Rick. Do you have a breakdown text or photo of the kit. I'm from NewZealand and unable to this info. Cheers JB. ciaojb@hotmail.com
Results 1 to 19 of 19