I used the plug and play wiring harness from Can Am Spyder Accessories. There are four pins. When I plug the leader into the plug on the bike with no trailer the hyper flash continues. Unplug the...
Type: Posts; User: Mjhitman
I used the plug and play wiring harness from Can Am Spyder Accessories. There are four pins. When I plug the leader into the plug on the bike with no trailer the hyper flash continues. Unplug the...
I keep on getting the hyper flash of my turn signals on my 2016 RTL. I have used the Lamonster Garage reset technique and it will work. But as soon as I shut it off and restart it and rid the bike...
THANK YOU! My point exactly!
THANK YOU! My point exactly!
That's good to hear, I have 14awg run so far, so it should be good. Another thing is, what is the link for the relay and diode you recommend? I've been looking out there are so many choices. Thanks!
What is the wire size you used for the bike and trailer?
Ok, so no isolator or relay? I like your system the best!
Looking at your diagram, was wondering what type of charger you are using. I see it is powered by 12v starting battery.
Thank you Bert for your concise explanation of how to wire what I'm trying to accomplish. I like your idea of putting the isolator in the trailer before the Aux battery. What type of isolator are you...
The charging system for the batteries should be enough. Bike starting battery through the trailer connection to the trailer battery.
Thank you!
Thank you for your post on my question. Would you know of any type isolator with the 1 way current flow you would recommend?
I am wanting to charge a RV battery in my Timeout Slipstream camper which I pull with my 2016 RTL. I have run positive & negative wires from the cranking battery to the rear of the bike with a fuse...
Got a call from my dealer doing the sprocket recall today telling me that the front sprocket is seized, and they can't get it off! They tell me this is a first for them and they have a call in to...
I know this should be a simple answer but here goes anyway. I just got the CM1044 T-Valve Stems from Cyclemax for my 2016 RTL. Putting a new rear tire on and want to upgrade to the T-Valves stems for...
I called my local dealer and talked to a service rep and they said the same thing. Clean and inspect and re-use with blue loctite.
On this same topic, it seems that the rear bolts for the disc and the encoder wheel also are to be replaced. I guess they are not very confident of the metallurgy of the bolts.
In the process of reading the service manual for the 2016 RTL and came across: "Install caliper with NEW screws." What's up with that? All of the videos forums that I have read say nothing about...
I have a 2016 RTL, today at slow speed I noticed a wobble and thought that my rear tire was going flat. The FOBO was reading 31lbs and I thought it was a wrong reading. I got off the bike and found...
It too a little longer than a couple of minutes but the rag was used just like you recommended and I left the wire connected until it was out. A long pair of needle nose pliers came in handy too....
Ok Joel, got in there today and got all the way into the loosing of the bolt for the sensor. As they say no guts no glory! Any tips on getting the bolt out without dropping it into the engine and...
I have a 2016 RT LTD and as most have commented the radio reception leaves a lot to be desired. I was wondering if any antenna booster is available to possibly help with the reception?
I went with the Can Am Accessories hitch, much stronger than the BRP hitch.
https://www.canamspyderaccessories.com/rt-trailer-hitch/
Just bought the Ultimate Tall Boy with Passenger Backrest and have no use for the original seat. Very low use and in excellent condition. Would like to sell both seat and backrest $300.00.
...
I have run the wiring from the battery back to the rear for the brake controller that I have mounted inside the rear top trunk. I already have the 4 pin flat along with the 2 extra wires for the...
Thank you for your response. All of the locations that you suggested are preferable and if they have clearance and should be doable. Unfortunately a new work week is upon us and will have to wait...
All of the locations that you suggested are preferable and if they have clearance, should be doable. Unfortunately a new work week is upon us and will have to wait until time permits. Will keep you...
It is a Tekonsha VoyagerŪ Electronic Brake Control, for 1 to 4 Axle Trailers, Proportional. It is activated via the brake light circuit with a sensor inside which increases braking force in...
Just got the TimeOut Deluxe with the added electric brakes. The dealer installed the brakes with a separate 2 pin plug for the brake circuit. Any ideas where I can mount the Brake controller on a...
I am on the hunt for a used camper trailer for pulling behind the RT. I have been looking at all the different models and types. and still haven't determined which is best for me.
Of course price...
Ray,
What format is your thumbdrive?
PC or IOS?