Been there, done that. I had a Polaris Slingshot and did that to load, plus a beavertail and taller bumpers on the ramp door.
Type: Posts; User: captcharles
Been there, done that. I had a Polaris Slingshot and did that to load, plus a beavertail and taller bumpers on the ramp door.
Pictures?
Looks like they're not available. Several sites said no longer available. Looks like a great solution though.
What are the wood blocks for?
Do you use 3 ramps?
So the 2x6 are laid down on the ground before the loading ramp?
Do you have trouble loading from the rear ramp? Such as bottoming out on the way in? Have to do anything to raise the front of the trailer to do that?
Thanks:yikes:
2022 RTL. How do you tell if the rear air compressor is working? I've been told that you can hear it. My passenger is 175 pounds. She'lll get on and I start it with both of us on.
I've never...
22 RTL
Looking to get a 6x10 enclosed cargo trailer. I've seen posts that say it will fit. But is there enought room with the Spyder loaded to get around to for tie down straps to be attached to it...
About 6 months old. Just upgraded the firmware. Phone connection work great the whole trip.
Not in ECO mode. I was picking up speed to pass then she (the car) sped up just a bit so I went wide open throttle and nothing.
I did not have an error messages or flashing anything. I was on a flat piece of road so it didn't occur to me to change gears. I was shocked at the performance and ran out of time to pass the car so...
Took my first long trip with a passenger on my 22 RTL this weekend. Went to pass a slow-moving car and I couldn't get any more than 63 mph with wide open throttle in 6th gear. What the heck is going...
Took my first long trip with a passenger. The intercom would turn itself off without me touching the controls. I could hear the beeps indicating it was turned off. Ghosts?
Cardo only said...
Here's picture. I pulled the "gasket" up to show the offset of the antenna in the hole to see that there's no way (that I can see anyway) to push that lower "skirt" gasket in the hole with the...
Thanks for trying. I appreciate it.
Tried that. Not anywhere near enough room to push between the hold in the body and the body of the antenna.
I can get the skirt of the gasket in the hole but it's folded and I can't get the antenna in the hole. Doesn't seem like there's enough room between the tupperware and the antenna mount plate for it...
It's a 22 RTL. I don't understand your reply. The gasket won't fit back into the hole. If it cram it in the skirt on the bottom is folded in the way and you can't even see the mount socket. It looks...
I was checking the antenna. It seemed loose. Sure enough, the dealer never screwed it in to the socket. The rubber gasket was the only thing holding it on. I figured out why. The socket couldn't be...
So is the Cardo supposed to sound when the phone rings?
Was out riding this morning and got my first phone call with my Cardo Freedom 2X. One problem. I heard nothing in the helmet when it was ringing. I could only hear it ringing in my pocket. At first I...
2022 Spyder RTL. Ordered these mirrors from Slingmods. When trying to dry fit these I found that the plastic rim on the back of the add on mirror was a bit too small to fit over the factory mirror...
I've been seeing that there's a software upgrade for something about low compression. I looked mine up and it says v710007226. Anyone know if it's up to date for my 2022 Spyder RTL?
Thanks
I've been seeing that there's a software upgrade for something about low compression. I looked mine up and it says v710007226. Anyone know if it's up to date for my 2022 Spyder RTL?
Thanks
I tried the link to the store a couple of times. Didn't work. I think it' www.spyderstore.com
How do you check firmware version?
Inquiring minds want to know (that includes nubee owners).:pray:
Kept getting a C1290 code. Dealer said power problem. Dealer is a 20 hour trip so cheaper to put in a new battery. And wanted to put in a LiIon one.
22 Spyder RTL. I just put in a new NICO LiIon battery. Two of us spent an hour trying to mount the hold down bracket. I even called the dealership and one of the techs could only say it's tricky....
I just did a fairly long ride with my new shift pad. I really like it. Well done job in design.