Search:

Type: Posts; User: Chupaca

Page 1 of 17 1 2 3 4

Search: Search took 0.04 seconds.

  1. nice diy

    Good job guys. always good to see diy projects solving issues we have...:clap::clap:
  2. Replies
    8
    Views
    311

    Both good...

    Saw your Ryde in both the garage and the album.:2thumbs: when doing the garage it takes time to get the approval so it seems not to work....:thumbup:
  3. Thread: Ryker mpg FYI

    by Chupaca
    Replies
    5
    Views
    128

    Good to know

    Know many are waiting for those kind of stats...:bowdown:
  4. Some confiusion

    Many times listings are miss printed as the common discription for an RS will be RS Sm5 or RS Se5 so some list RSS when it is only an RS. Some came with a big RSS sticker on the frunk (front...
  5. Ahhh yes...!!

    Another great Ryde through the countryside of Europe...:bowdown: and I never run out of gas...:roflblack:
  6. Replies
    6
    Views
    268

    Welcome, welcome 👍

    Nice review..:clap: looks like you tweaked the rich points and are well on your way to the miles of smiles. And with a few more tweaks you'll be hugging a lot better and a bit faster..:thumbup:
  7. Replies
    6
    Views
    205

    Curious...🤔

    Do you remove the key when you shut down and give the computers time to shut down..? If so try disconnecting the battery. Did they change the vacuum hoses to the throttle body if not change them...
  8. Replies
    19
    Views
    420

    A lot with a little

    A lot of sad and bad with some good news too. :pray::pray:'s to both do miss Bob here...
  9. Thread: P0172 reflash

    by Chupaca
    Replies
    3
    Views
    158

    Interesting....🤔

    Must not be a big issue as they say Ryde on with lower octane fuel...:dontknow: on the old twins it usually just need to replace the vacuum hoses....
  10. Replies
    1
    Views
    88

    Ahhh yes...!!

    Those pesky little hoses to the throttle body. Silicone replacement is thevonlyvway to go cut to the same length. O2 is probably still good but also check the intake manifolds for same cracking as...
  11. Replies
    28
    Views
    672

    It is recommended that bolt NOT be reused as well...

    It is recommended that bolt NOT be reused as well as the washer. I replaced them as well as the flywheel weight bolts. They come with the loctite already on them...:thumbup:
  12. Replies
    28
    Views
    672

    Strange as it may seem... when I re-torqued it so...

    Strange as it may seem... when I re-torqued it so I could keep rydeing till the parts came in from Cheapcycleparts.com I could not go to the full recommended torque as I could feel it stretching or...
  13. Thread: SAE connector?

    by Chupaca
    Replies
    8
    Views
    168

    Well....

    not looking like any heated gear plugs I have been around but could be. I would think it is more likely a battery connection. If you can get to your battery you will see the connection...
  14. Replies
    9
    Views
    461

    HowTo: Not sure...

    you have a 2014 and I don't think they were still using the shutter system on your model. If you have a dual filament bulb you do not have the shutter system. Mine has a single filament H7 bulb so...
  15. Thread: 20-50 w oil

    by Chupaca
    Replies
    13
    Views
    279

    Once again....

    Comes up from time to time and as a rule of thumb if you are in a warmer climate 20/50w works fine. Now if you are fine with changing back and forth as you do have cold weather as well then do the...
  16. Replies
    28
    Views
    672

    Very similar...

    175099 175097 175100 175098 On mine the bolt streched and was loose, the sprocket would slide about drying the shaft and creating the rusting. You can see the end worn on the sprocket compared to the...
  17. Here's the thing..

    It would have to be proven that they were the cause of the incedent. Be it insurance or warranty and it could go to anything like oil, gas, filters, pads, plugs etc. Have not seen this happen during...
  18. Replies
    7
    Views
    193

    Well done....

    Always good to see the DIY project and how they work out. Should keep things clean in there for a good amount of miles more than stock....:2thumbs:
  19. Replies
    4
    Views
    167

    Agree...

    There will be an improvement as Ron has explained above. BRP has always been middle of the road on the bar so for many it is just fine as they do less than agressive ryding. You can go it step by...
  20. Replies
    6
    Views
    216

    For sure....

    dealer can hook up to buds and get you the codes and clear them as well. Strange that you would have the orange screen without a code or a warning light like , oil, brakes, VSS, DPS etc. Those...
  21. Replies
    6
    Views
    216

    For sure....

    dealer can hook up to buds and get you the codes and clear them as well. Strange that you would have the orange screen without a code or a warning light like , oil, brakes, VSS, DPS etc. Those...
  22. Replies
    10
    Views
    357

    Battery....

    You said the battery is 14 months old so I wonder what brand it is and is it the oem battery. There are some battery testers that plug into the cigarette lighter and will give you condition and...
  23. Replies
    7
    Views
    281

    Nice novelty.....

    Most understandable on semi's and transport vehicles. Many cars have them built in now to let you know when a tire is low. When they were introduced for the spyder there were issues and in the end...
  24. Replies
    6
    Views
    350

    as I see it....

    This would be a time lapse warning and not a condition warning. So should it come up you would have plenty of time to make an inspection and or change as needed. A lot will depend on the type of...
  25. Thread: Ryker Fun

    by Chupaca
    Replies
    15
    Views
    608

    Soooooo...!!

    Where was the fun part...?? :roflblack: hate to work in those conditions just sweat all over the work...One of those swamp cooler fans helps a lot....:thumbup:
  26. Thread: 2010 RT issues

    by Chupaca
    Replies
    8
    Views
    220

    Interesting....🤔

    As to the oil..... you can only get an accurate reading when the engine is at operating temp. Do not add any oil if you measure cold or you will have it coming out all over the place....The clusters...
  27. Replies
    12
    Views
    267

    Impressive....

    Gonna be hard on the old timers and young-ins.... I mean a Harley with no sound......:yikes::roflblack:
  28. ta🎶da....

    So that's it....you can now ryde on knowing that issue will not rear it's ugly head...:riding:
  29. Replies
    3
    Views
    1,240

    So I've heard...

    :agree: what he said but... we will see:spyder: you never know ...🤔
  30. Replies
    19
    Views
    574

    Sad News....

    Well to be honest it happens on all roads. I do ryde more causiously on farmland areas for that very reason. Too many feel they are just going down the road a mile or two so why tie things...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4