Search:

Point taken but I figure if the factory has something in place thats suited for the seat, there shouldn't be any issues with my intended purpose. (e.g. Right gauge of wire, proper fuse, etc.)
...

Hello Spyderlovers!

I know there are some aftermarket options for heated seats but I'm specifically interested in whether BRP offers a heated seat up grade for my 2019RTL.

If they do, I'm...

Thank you! I was excited to find this photo but I'm afraid I don't quite know where in the photo to look. Hunting for what appeared to be the "gas tank ground bolt" as a landmark but I'm still...

By chance do you know where I can find a diagram like this for the 2019 RTL?

Thanks in advance!

Hey there! This is the intel I've been scouring for here in the forum for my 2019 RTL. Can you tell me anything else that would help me identify this connector with certainty?
How many leads?...

Interesting. Thank you. I did skim down through then entire FSBO sub-forum and did a search for "hitch" but I must have missed this one. I'll contact the seller.
I had previously gotten the...

OK, Some interesting replies, gents. Not at all what I was expecting but let's run with the notion that essentially "you're driving it wrong" for a hot minute...

So if the on board computer is...

Hello!

I'd like to pull my Escapade trailer with my Spyder but I'm pretty tapped after the purchase of the Spyder itself. I've looked at and read about the cheaper, aftermarket hitches but I'm...

Greetings Spyderlovers!

I just acquired a used, 2019 RTL from a private seller. It's in showroom perfect condition with just over 5K miles and plenty of extended warranty left. I was pleased with...

It happened again. My 2010 is throwing P1614 after only about 1200 miles since the throttle body was replaced with the 3rd generation part in September. I always run premium fuel and use Sea Foam...

Thanks for the input everyone. Not exactly optimal riding season just now here in Washington state. If there's a break in the weather, I'll try and get it in somewhere for a look-see. Will let you...

This thread spawns a couple questions for me as it may tie in to my other post.

1. I'm very interested in knowing the specifics of the handling experience and symptoms that ryders encounter before...

Greetings from Washougal, Washington!

I'm a little past the 1 year mark and about 6,000 miles of road time with my 2010 RT SM5.

One thing I've recently noticed is that she bobbles around a...

So pardon my ignorance here. I've read a little about cat delete and the main advantage that stood out to me (as I understand it) was that you end up with a little more power. I pull a cargo trailer...

Greetings from Washougal, WA!

I started this project of DIY magnetic mirror mount (mmm for short) for myself but I ended up abandoning it and just bought the pre-made set from Lamonster.

I...

Ahh! I like that latter suggestion a lot, @AeroPilot!: Lift her to stretch the range of motion of the suspension but not enough to float the wheels in the air.

That's a really great tip! Thank...

Thats PRECISELY the input I was looking for, Mike. A very creative suggestion about the ramps. I'll try that next time. Meanwhile, the remedy for getting the rear up in the air is also excellent. I...

Greetings Spyderlovers!

I've browsed several posts tonight about jacking up the Spyder for maintenance and most of them seem to center on the discussion of an ATV lift (or something like it) and...

Spectacular. Thank you!
David

Greetings from Washougal, WA!

I'm gearing up to pull the tupperware for an oil change and also tackle a couple of mods while i'm in there. For the canister-ectomy, I'm working from the...

Does anyone recall the diameter info for hose #24 and the coupler? I want to make sure I pick up the proper supplies for extending it down the frame a bit (as instructed).
It would be nice to have...

I found both the small hose clamps as well as the glass fuel filter at O'Reilly Auto Parts.

Ron, thank you for sharing your expertise and creativity with the community. Will PM you shortly about...

So for future generations that are researching this issue, this: ...

Ahh. So I found this link: https://www.spyderlovers.com/forums/showthread.php?110965-Up-date-on-oil-catch-can-08-GS&highlight=catch-can Seems like a variation on the catch can concept to address...

So it's a LaMonster product or a BajaRon product? I've searched the LaMonster Youtube channel and found only an oil change instructional video. Nothing about an "oil catch can".
Can someone send me...

I just stumbled across this post and am very interested to learn more of this local, private mechanic in the Portland, OR metro area.
I searched through JerryB's posts and noted he sold is ryde...

So I went to the BajaRon link from the homepage here @ Spyderlovers and I don't see any reference to a product fitting this description. Lil' help, please? :helpsmilie:

HUGE thanks!
David

A good question. I just acquired this RT in October of 2018 at a dealer up in Lacey, WA. At the time of acquisition, it had a mere 2,700 miles on the odometer. I've put on 5300 during this past...

Interesting you mention the oil loss issues as that is my other major concern with this machine.
I've monitored some excessive oil consumption on this 2010 as well. To the tune of around 1.5 quarts...

Hello all,

At only 8K on the odometer, my 2010 RT SM5 is throwing the dreaded P1614 code so I've been reading up on this issue here and on other forums.

For as rampant as this issue appears to...