Thanks, I do know the 998 is high rev and should never let it get below 4500 when driving. I was just curious if the RPMs bounce around when at idle.
Type: Posts; User: rwyma
Thanks, I do know the 998 is high rev and should never let it get below 4500 when driving. I was just curious if the RPMs bounce around when at idle.
Have a 2013 RT and when I start it, RPMs jump between 1300-1400 continuously. Is that normal? Just replaced spark plugs and wires.
Thank you JKM, I did look again in the package and you are right, it is the small pak. Didn't nitice it at first because they were together. But all is good again, and thanks again.
Changing plugs in my 2013 RT and shop manual calls for heat sink paste to be put on plug threads. So my local dealer has the paste, $38.99, enough to do 500 plugs. Have searched locally and no one...
Thanks Grandpot.
I know I have read you need to take the whole front off to get the resonator out. What exactly is its function and if you install the JT filter, will it throw codes if you leave it in the bike.
Hey guys, is it necessary to remove the resonating chamber. If its as much a pain as getting the air box out, why do it. Also why remove the air intake. Seems like that would just bring in cool air...
Grandpot. Do you have a link to his site. I search JT air filter and nothing.
Thanks Peter, ended up taking it out the right side. Undid the frame brace along with the 50 connectors and a bevy of all sorts of "things". Even than it was near impossible to get out. I don't know...
Have a 2013 RT L and changing the plugs. I know it seems everyone takes the air box out the right side, but that requires removing the frame strut on that side. I have the center console out and it...
Can someone please tell me the torque settings for the rear rotor, caliper and axle nut. Have a 2013 RT L. I found them for a 16 RS but not sure its the same on mine. Also was said 177 FtLbs for axle...
Discount tire did mine, no problem. Couldn't balance it.
Have a 2013 RT. Anyone know if the torque settings mentioned above are the same for the 13.
The rear axle nut is really 177 ftlbs? How do you tighten the nut with the cotter pin? I have a 2013 RTL.
Attempting to replace air filter and its turning into a nightmare. Finally found the housing and could release 2 on the clips but clip on bottom seems impossible to release. Any tricks to this....
Thanks all. Got the seat open and just going to hold the latch open. The funk is a different story. Got it open but now will not close and latch. The latch will close when I do it manually but when I...
Thanks guys. When I turn the key either way, trunk or seat, do not get the same resistance that I did before. Could both cables go at the same time. And any suggestions on getting the key cylinder...
2013 RT Limited. Neither my frunk or seat will unlatch from the key or the switch on the dash with Park. The key seems to turn different when I push it down and turn to either seat or frunk. Does the...
Thanks all. Answered my question. Much appreciated.
I want to remove the plastic panel that covers the main instruments on my 2013 RT. Looks to be 4 screws. My question is will the panel come out and leave the main cluster in place or is the panel...