Search:

There is no switch harness, you pull your own wires to the switches, and solder them to the switches themselves, unless you are referring to the cruise switches you pick when you buy the package?...

Yeah, seems like embellishment to me on them specs. If they are true 200W a piece I would be scared to put them in anything short of glass and/or a metal enclosure. And simply looking at it there no...

SlingMods states 30W
200798

possible be correct because it does have a boost driver on it I think, at about 19V so that will bring it down to ~30W or so

Just went out to garage and checked with Mr. Fluke, these are the Elite LED HD 360:

PER BULB @ 14.4 VDC idle
HI - 2.4A = 34.56W
LO - 1.3A = 18.72W

HI = 4.8A Total
LO = 2.6A Total

hmm, wonder if that shock lift kit would help on this also, need that also as the stock shock is not very good... until maybe get the elka setup perhaps this be a compromise until then, thanks

any recommendation for a rear shock? Is this setup noticeable, when looking at side view is the front markedly higher than back? thanks

Found a spot right about the upper shock bolt, holes are already there. I had a piece of 1in heavy aluminum angle, cut it to fit. Found some light brackets on Amazon, drilled it out a bit to work...

This, exactly. When she wanted brighter lights and found that the LED bulbs are a PITA to deal with unless you have your tools with you, I installed a set of aux lights on hers, and she loves it....

Seem to recall on the wife's ryker it was 3 torx bolts (2021), but it sure was easier to do that than to fight it while it was attached. Spent more time trying to get old one out and new one in. Just...

There are rumors folks can do it without removing the frunk and headlight assembly, but I could not do it. It was just easier for me to take it apart, it just to damn tight to shoehorn a bulb in...

would be advantageous for you to get a service manual if you intend to do as much of your own wrenching as possible, best $15-$25 bucks you will ever spend, especially for these things, nothing is...

The threaded part in the max mount is sort of shallow, perhaps half inch or so in depth, if that much, and of course the max mount is canuckistan aluminum, so not very strong either. A better bolt...

I put one on the wife's ryker, and put a Chase Harper 4250 on it. She doesn't do any traveling, just for her garbage she picks up or takes for her job commute and/or joy riding. Would say she has had...

196422
196423

.....

Seeing as there are no schematics posted here, and I didn't read anything forbidding posting them, I exported the 2021 Ryker schematics from the service manual.
Delete if not appropiate and/or...

2021 Ryker 900 states 63ft.lbs. upper, 35ft.lbs. lower ball joints
196256

EDIT: made post more clear