Search:

Type: Posts; User: Rattlebars

Page 1 of 17 1 2 3 4

Search: Search took 0.02 seconds.

  1. https://www.lamonstergarage.com/belt-tensioner-idl...

    https://www.lamonstergarage.com/belt-tensioner-idler-pulley/

    I have an OEM tensioner with a Lamonster bearing...
  2. as per mike's earlier recommendation I bought and...

    as per mike's earlier recommendation I bought and installed Toyo Proxes T 185/55-15 and the nanny on my 2016 loves them as much as I do. No complaints from her at all. Ridden in all sorts of weather,...
  3. Don't know if this will help.... might be pre...

    Don't know if this will help.... might be pre D.E.S.S.


    https://www.youtube.com/watch?v=a8xbXEE_ky4&t=729s
  4. Once you get Two (2) keys (minimum) done put one...

    Once you get Two (2) keys (minimum) done put one under the service door hidden. You will save lots of money and grief. Get your son to pay for them and the new key unit and the programming and all....
  5. by 2018, resetting the canbus by using the hazard...

    by 2018, resetting the canbus by using the hazard lights to cure hyperflash went away. Not sure if this is true or not. Been asking for years for someone to confirm it's gone, but have not gotten a...
  6. I made my own! So can you! ...

    I made my own! So can you!

    https://www.rattlebars.com/heated/
  7. Separate part #. 193633

    Separate part #.

    193633
  8. Replies
    23
    Views
    1,554

    Another wise habit ... never get gas @ a station...

    Another wise habit ... never get gas @ a station that has a tanker parked in it filling the underground cisterns. That stirs up all sorts of stuff into the fuel in the cisterns.
  9. Replies
    4
    Views
    897

    There are raised panels on each end. Insert...

    There are raised panels on each end. Insert finger from the front and lift. Get some plumbers grease and put on the pins to make it easier to do next time. Lifting from the rear of the panel will...
  10. Replies
    24
    Views
    1,871

    PC is not for me. All it does is change the...

    PC is not for me. All it does is change the throttle position sensor to "already on." Say to get the stock acceleration normally you twist the throttle from 0° for none to 90° for full acceleration. ...
  11. Good choice. Both fine machines. My 16 has many...

    Good choice. Both fine machines. My 16 has many features that the later models had eliminated. Older models many have better performance than newer.
  12. Ultimate seat revived my ability to ride without...

    Ultimate seat revived my ability to ride without back pain. Added my own backrest to it. Details at link in my signature.

    193221
    193222
  13. I don't winterize. I have heated gear (make your...

    I don't winterize. I have heated gear (make your own -> https://www.rattlebars.com/heated/) and find a way to ride all year 'round (much easier now since I have a winter home in SC :D ) If there is...
  14. Start the bike which should resolve a low battery...

    Start the bike which should resolve a low battery condition.
  15. Replies
    37
    Views
    3,712

    192896 192897 running these and love them...

    192896
    192897
    running these and love them (Thanx Mike). One must shim the fenders toward the bike using a pair of lock washers @ the bracket mounts. Complete details @ the link in my signature.
    ...
  16. Replies
    13
    Views
    1,177

    Sounds like a balance issue. Improper balance...

    Sounds like a balance issue. Improper balance from the start or you may have thrown a wieght. I'm running Toyo Proxes T 185/55-15 up front and since the tire shop did not have "cones" small enough to...
  17. From the fiche @ Partshark. If you do have the...

    From the fiche @ Partshark. If you do have the #350 one, double check the two mounting bolts #350a. The Loctite coating on them is so thick they take loads of torque to completely tighten down snug...
  18. Replies
    11
    Views
    1,163

    I have no problem using Rotella t6 5W40 and this...

    I have no problem using Rotella t6 5W40 and this time using Castrol 5w40 synthetic. Both purchased at Wally World for cheeep. Castrol seems to cause a bit of delay when starting out cold, but it...
  19. Replies
    2
    Views
    717

    From amazon. I've been using this as a...

    From amazon. I've been using this as a broadcaster blue tooth to my headset from my old tv. My new tv has BT built in. I have switched this to receive and use it through the aux input on the F3. For...
  20. Replies
    15
    Views
    1,799

    What does that mean? If your idler is loose at...

    What does that mean? If your idler is loose at the base where to the bolts are, it will eventually blow. Grab a ratchet and tighten the bolts. I believe they are 12mm.
  21. Replies
    25
    Views
    2,331

    Informative post with ONE EXCEPTION! The tires in...

    Informative post with ONE EXCEPTION! The tires in the photos are NOT NAMED. Are we to accept "expert" testimony with such absence of vital information?
  22. Bert. Please always give the year of your bike. ...

    Bert. Please always give the year of your bike. They change most everything each year and consistency on solutions is patchy. Contact TricLED for a replacement of the side light. Sometimes they die....
  23. Replies
    10
    Views
    1,806

    By the wear pattern, it is "obvious" that the...

    By the wear pattern, it is "obvious" that the idler was left loose after your recent service. The idler was moving and dragged into the belt which melted the arm and destroyed the roller. I would...
  24. Replies
    22
    Views
    4,170

    There are many work arounds for those sources...

    There are many work arounds for those sources problems. You can set iTunes to do mp3 instead of ACC. You can get music off of many sources with "audacity". I wont' detail other ways, but there are...
  25. Replies
    13
    Views
    1,012

    I have an idler and replaced the roller with...

    I have an idler and replaced the roller with Lamonster's roller. Luv it. No vibes, nice ride.


    https://www.lamonstergarage.com/can-am-spyder-f3-rt-belt-tensioner-idler-pulley-lamonster/
  26. Replies
    5
    Views
    1,071

    I installed a set of goldwing horns in the cavern...

    I installed a set of goldwing horns in the cavern under the frunk liner. Got them for less than $20 off eBay. Had great result with that. One must be aware that the OEM horn is switched by the ground...
  27. Replies
    20
    Views
    1,804

    @72 with agent orange and arthritis, I need LOTS...

    @72 with agent orange and arthritis, I need LOTS of windshield. I have an f4 no vent 25" to which I added several things to accommodate my disabilities.

    Visit the link in my signature to see...
  28. Replies
    19
    Views
    1,923

    Well, I'm in the 9000 mile group. Tire was...

    Well, I'm in the 9000 mile group. Tire was showing cords (Kenda) and rear OEM pads were nearly gone, so much so that I had a heck of a time getting the rear piston started onto the threads!

    I'm...
  29. Replies
    8
    Views
    951

    Cat pics! 190525

    Cat pics!

    190525
  30. Think I got you beat. ;)Bought my air hawk at...

    Think I got you beat. ;)Bought my air hawk at @Daytona Bike Week in 1997. Has served me well for 24 years. You are correct about inflation. Just a little bit. The actual trick to using them for long...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4