Search:

Type: Posts; User: SpyderJerry

Page 1 of 6 1 2 3 4

Search: Search took 0.03 seconds.

  1. I have had that happen on my last 2013 RT and on...

    I have had that happen on my last 2013 RT and on the 2014 RT that I have now. Luckily on the 2014, it was the pinch bolt on the joint at the DPS that needed tightening. Could get to it with extension...
  2. Ron, those were EBC MD853 rotors

    Ron, those were EBC MD853 rotors
  3. I just went through that on a 2014 RT SE6. I...

    I just went through that on a 2014 RT SE6. I bought it with issues and the front right shaking when applying the brakes was one of them. Replace rotors and pads, had same problem, same wheel....
  4. could very well be a bad soldier joint at the...

    could very well be a bad soldier joint at the board where the connector pins attach. I just did that on my 2014. you can unclip the lens and remove the board from the housing, look at joints where...
  5. Thread: Zumo 660

    by SpyderJerry
    Replies
    5
    Views
    1,011

    FS: Zumo 660 still for sale $125.

    Zumo 660 still for sale $125.
  6. Replies
    8
    Views
    1,200

    I use scratches happen. They match very well....

    I use scratches happen. They match very well....
  7. Thread: Zumo 660

    by SpyderJerry
    Replies
    5
    Views
    1,011

    FS: Not sold yet

    Not sold yet
  8. Unfortunately the #" is too tight and if you look...

    Unfortunately the #" is too tight and if you look at the bag fully inflated and under weight, it will be mushrooming out over a 3" cap. It may eventially wear through the bag where it contacts the...
  9. Just finished replacing air spring on my 2013 RT...

    Just finished replacing air spring on my 2013 RT SE5. Used the rubber 4" end cap( wish there was a 3 !/2" would be perfect) Did the complete job with just removing both side panels and above plastic....
  10. If the pull goes with the tire location, it is a...

    If the pull goes with the tire location, it is a tire problem. Possible broken ply in the tire. Replace tires.
  11. I have just dealt with this a few weeks ago on my...

    I have just dealt with this a few weeks ago on my 2013 rt. Both the upper and lower pinch bolts needed to be tightened as it had a little slop on the splines. Of course that meant pulling the upper...
  12. Thread: Zumo 660

    by SpyderJerry
    Replies
    5
    Views
    1,011

    FS: Zumo 660

    Garmin Zumo 660 for sale, Has base mount, power cord and usb cable. Is update to lastest download and has lifetime maps. $200 including shipping in US. jerrytennant@charter.net.

    unit sold
  13. RH Radio Antena Base 708300156 Plug number in...

    RH Radio Antena Base
    708300156 Plug number in google, you may find it from another source than dealer. $19.95
  14. Replies
    2
    Views
    366

    WTB: I have done 2 frame replacements on 2 x 2013's. I...

    I have done 2 frame replacements on 2 x 2013's. I bought new frames from dealer for around $1000. The probelm with finding a crashed donor is that the frame is usually damaged.
  15. Of all the different black plastic restorers I...

    Of all the different black plastic restorers I have used, this is the only one that worked and after a year still looks fantastic....
  16. Full kit number 219800263 for 2013 RT SE 5 On...

    Full kit number 219800263 for 2013 RT SE 5 On ebay for under $80
  17. Replies
    16
    Views
    1,388

    When my friend who has a 2005 1800 Goldwing trike...

    When my friend who has a 2005 1800 Goldwing trike and I ride together(mine is a 2013 RTSe5) we get about the same mpg. Any where from 30 to 34. Normaly driving 60 and below on secondary roads....
  18. Replies
    25
    Views
    2,406

    What ussualy happens is the pulley will have...

    What ussualy happens is the pulley will have spline left on the inside of pulley that catches the spline on the shaft. I used a gear puller to get them off. You can possibley hold the shaft still and...
  19. Replies
    24
    Views
    2,432

    I should clarify that I mounted the Dvr in the...

    I should clarify that I mounted the Dvr in the rear trunk. It comes with a wired remote controll that I mounted on the dash cover. The remote has a blue light that flashes to let you know it is...
  20. Replies
    24
    Views
    2,432

    This is the unit I use and is waterproof....

    This is the unit I use and is waterproof....
  21. Replies
    7
    Views
    917

    Lockpicks has not had them available for about a...

    Lockpicks has not had them available for about a year now.
  22. Replies
    7
    Views
    917

    Yes they as well as a locksmith can clone the key...

    Yes they as well as a locksmith can clone the key to start your bike.
  23. Replies
    7
    Views
    917

    Got a Spare key for early Spyders!

    Anybody looking to get a spare key for their 2008 to 2013, google a ZD23RT5 key. It was not available for a while, but just got 2 blanks from ekeyblanks.com and had Ace hardware cut and clone a spare...
  24. If you put the bike on jack stands or other, you...

    If you put the bike on jack stands or other, you can remove the bottom left belly cover to reach it
  25. Replies
    11
    Views
    799

    I have been using the Harbor Freight bublle...

    I have been using the Harbor Freight bublle balancer with no problems. https://www.harborfreight.com/search?q=tire%20balancer
    I use stick on weights.
  26. Replies
    12
    Views
    1,492

    Push your mode button until trip meter screen...

    Push your mode button until trip meter screen shows. Push and hold bottom button to zero. Push side arrow buttons to change from a and b trip meters.
  27. Also, make sure you check your battery...

    Also, make sure you check your battery connections. Grab the cables at the battery, if you can move either, clean and retighten the connections. Had the same happen on my 2013 with the same symptoms....
  28. On my rt which uses the same type of latch. I...

    On my rt which uses the same type of latch. I found that the return spring at the latch was on the wrong side of the release lever at the latch. had to remove latch and reinstalled spring on the...
  29. Both 2013 RT SE5 ( that I rebuilt and replaced...

    Both 2013 RT SE5 ( that I rebuilt and replaced frames) did not have serial numbers stamped in the frame. This was also verified by dealer and BRP. The Serial is on the swing arm, left side. then...
  30. Replies
    11
    Views
    1,773

    If it bent the wheel back, chances are the frame...

    If it bent the wheel back, chances are the frame may also be damaged. Look closely at a arm mounting areas.
Results 1 to 30 of 170
Page 1 of 6 1 2 3 4