Seems like the guys that make the machine should know what it takes to transport it. Not impressive at all!
Type: Posts; User: h0gr1der
Seems like the guys that make the machine should know what it takes to transport it. Not impressive at all!
:agree:
The spring compressor Ron offers is so good I went ahead and bought mine. Very good piece of equipment meant to work with the smaller coil size on the Spyder.
...
https://www.youtube.com/watch?v=nA8ipXtzHrY
My experience (simulated) switching from Kenda to Vredesteins all the way around!
Think I read somewhere the Spyder ground is always black.
The motor will be in the casing around the pedal/front sprocket assembly.
Looks to be electric. Under Specs it shows 48V/350W.
My 2018 is the same as yours. The battery isn't too bad, as long as you have the super double top secret handshake. By now you know it's in the frunk, accessible by removing the 2 Torx screws from...
Mr Martin,
I'm not running a cat delete (yet) but unless you do a dyno run on each, what would be the point other than sound? Feel of the pants? That's OK, but perhaps the sound influences that.
That was one of the contributors to my failures, it would only manifest in the heat. Below about 90°F it wouldn't show up, everything acted normal.
The 2018's have some known problems with the left switch pack (something to do with the parking brake circuit), and also the parking brake motor. Mine had to have both replaced under warranty. By...
You could make a harness with the OEM style waterproof connectors (which I have seen referenced as AMP Superseal 1.5). That's the ones you disconnect to remove the mirrors. But then you'd have to...
http://www.operatorsguides.brp.com/OperatorsGuidesAttachments/OwnersManuals_SSA/attach/06/2019/619010EN.pdf
BRP Supplied 2019 RT Operators Guide. Read and print at your pleasure.
As an...
I too installed sequential front fender lights, mine had plenty of wire. I find it ironic that the manufacturer makes the main tie in down by the suspension waterproof with an AMP 1.5 Superseal, but...
When I juggled my rear shock in and out, I found I couldn't quite get to the top bolt and nut at the same time. I ended up removing all the Tupperware and using a long extension and wobble socket on...
Not an F3 Rider, but I think I read that the F3 Limited has self leveling rear suspension. If so, my RT Limited had the same problem when I made my rear shock adjustable. Simply put, the ride...
If it follows my pattern, you have 1 USB (The wide plug), a 2.5 mm microphone In, a 3.5 mm stereo line-out audio, and a 3.5 mm stereo line-in audio. What you can't see are the 12 VDC positive and...
I have some similar plugs on my Garmin GPS harness. Do you have the Garmin mount installed?
Mr. Steve W,
From the number of air system failures written about the air compressor seems to be the weak link. Take one of those cheap, small tire inflators and make it operate at 50-90% capacity...
I researched this pretty heavily and found some facts. Baja Rons spring adjusters are too small, they're for the front shocks. Here's what I did. Not too hard, but it reduced the pressures in the...
Note the car ramp under the rear. I didn't drive it up there, it was placed. I feel if you don't have to rotate the wheel (belt alignment/tensioning) or remove the rear wheel, this provides more...
I can attest to this style jack fitting under the Spyder RTL without any manipulation to the bike, and as to lifting, the one I got from Harbor Freight (I think they are both the same) lifts and...
I agree. even though I have read of a few premature failures, the Yuasa will fit without modifying the OEM hold down clamp. Buy it from a battery mart or somewhere other than a dealer though, my...
I did exactly the same thing, then to add to that I put the wheel and tire assembly on the balance shaft before popping the beads, and almost got a perfect balance without weights. When I got it to...
MR BLUEKNIGHT911,
On the DEKA battery I purchased, it listed a smaller number than the Yuasa of similar construction. But the battery guy showed me something. He load tested both the Deka and...
Unfortunately, my saving it to my computer apparently overwrote the original created date.
These are 2 examples of US made products. I suspect foreign products may have some supply chain problems in the near future.
https://www.yuasabatteries.com/battery/ytx24hl/
...
One very important piece of info, right on the sticker. Buy American.
181014
Probably a nice way of saying "Since you didn't let us rob you at the dealership, we won't help you". A lot of my experience with the San Am Dealership has been unfortunate.
I like your moniker, not a lot of folks remember what a windage tray is. I do my belt adjustment a little differently, and my dealer will set the belt at 1050N no matter what I ask of them, which...
I bought this one. It is Chinese junk, but probably made in the same factory as the Craftsman stuff. For as infrequently as I'll use it, and not trusting it for a second (see the alternate...