Search:

Type: Posts; User: peterRT

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Hi all", I replaced my drivebelt on my RT SE5...

    Hi all", I replaced my drivebelt on my RT SE5 Spyder. The job wasn't to hard. The only pain in the arse job was the 2 bolts at the rear of the belt gaurd. They were hard to get to the nut on the...
  2. Hi again", well maybe something did get under the...

    Hi again", well maybe something did get under the belt Mike. I don't know but it's done for whatever reason. Now i just got to fit the new belt and I ordered a krikit tool to measure the tension. I...
  3. Hi all", and thanks for the info I will remove...

    Hi all", and thanks for the info I will remove the rear shock bolt Mike so that may make it easier. I found X two teeth on the Spyder coming off a bit like when we were kids and we would get a loose...
  4. Thanks all who posted here and this is a good...

    Thanks all who posted here and this is a good website forum to find out how to do things on the Spyders. I use a Krikit tool when I put the new belt on to make sure the tension is at 160lbs, and I...
  5. Hi all", I got it organized now the job to do is...

    Hi all", I got it organized now the job to do is in the workshop Manual. Thanks to all who replied. It will give me something to do

    Regards Peter
  6. Replies
    36
    Views
    8,104

    Hi Bob this is an old thread but my belt just...

    Hi Bob this is an old thread but my belt just failed at 86000 kms and I've ordered a new one I will fit it myself

    Regards Peter
  7. My RT 2010 SE5 drive belt is kaput - any links to replace it?

    Hi all", went for a ride today and felt this clunk every time the wheels did x 1 revolution. Rode it home real slow and looked at the drive belt, noticed that it has a big lump on it on the inside....
  8. Thread: Hit a deer

    by peterRT
    Replies
    54
    Views
    4,737

    Hi mate", I hit a Fox last December and $3650.00...

    Hi mate", I hit a Fox last December and $3650.00 AU dollars to repair the front trunk, I also got rear disc pads replaced on the spyder while it was getting repaired. When I hit the Fox I was doing...
  9. 2010 RT Techno Spyder headlights not working - now sorted!

    Hi all, got on my 2010 RT Spyder Techno SE5 and all the headlights were not working; but no problem thanks to the forums in this room. Replaced the R6 30amp Relay in the front trunk and all is good...
  10. Replies
    12
    Views
    992

    Hi all", I haven't posted for a while', due to...

    Hi all", I haven't posted for a while', due to spyder Lover not working properly on google chrome so I use Mozilla Fire Fox now. I picked up my spyder a couple of months ago all repaired and I have...
  11. Replies
    12
    Views
    992

    Hit a fox a couple of months ago

    Hi all", I hit a Fox a couple of months ago on my RT 2010 Techno SE5 and did some damage to the front trunk, $3600 AU dollars damage but just cosmetic though. I have it down at a dealer and repairer...
  12. My 2010 RT SE5 Tricled LED 360 globes replacement

    Hi all", I replaced the top headlights on my 2010 RT Spyder with Tricled LED 360 globes and 'wow", what a difference it makes. now I just got to replace my lower foglights with the LED 360 globes. I...
  13. Hi Mate", I read it on a post somewhere and I...

    Hi Mate", I read it on a post somewhere and I can't remember where I read it. i checked the fuse under the seat which is number 7 a 30 amp fuse, but it was OK. I checked the 15 amp fuse in the front...
  14. I put an LED volt meter on the Spyder so that I...

    I put an LED volt meter on the Spyder so that I can keep an eye on the voltage,


    Regards Peter
  15. Hi Peter", all good now I just tried the same 30...

    Hi Peter", all good now I just tried the same 30 amp relay out of the radiator cooling one and it works fine now so I just got to by one now. The LED volt meter I put in the dash says 13.8 to 14V so...
  16. Hi Mate", cables are good and I just had new dps...

    Hi Mate", cables are good and I just had new dps fitted, wheel alignment, front brake pads replaced, 2 new front tyres, and new battery fitted. It was OK a couple of days ago and working just fine,...
  17. My 2010 RT SE5 headlights go off when engine revs?! Relay maybe?!

    Hi all", I jumped onto my spyder and the headlights were working intermittently, then went off all together . I start the spyder up and lights work then I rev the engine then they stop. Checked all...
  18. 2010 RT SE5 digital gauges working and volt gauge hooked up

    Hi Guys", I disconnected analogue gauges and put in a digital volt gauge too.

    Now I will see how accurate the digital gauge is.
  19. Hi all", I have adjusted my low beam by turning...

    Hi all", I have adjusted my low beam by turning the allen head screws. i can see the beam lowering and raising when I turn the allen head, however the allen head screws at the back that are supposed...
  20. Hi peter", yeah I read your post and the spyder...

    Hi peter", yeah I read your post and the spyder low beam lights at night are scary to ride because your can't see far infront of you. I feel like riding on high beam at night all the time, but I...
  21. Thanks Peter that explains a lot Regards...

    Thanks Peter

    that explains a lot

    Regards Peter
  22. I check to see if the cable to adjust the light...

    I check to see if the cable to adjust the light is working tomorrow

    thanks Peter
  23. Need High & Low beam adjustment on RT 2010 Spyder SE5?

    Hi all", I am having problem adjusting my high and low beam on mt Canam RT Techno. I have the instructions right beside me pages 496 and 497. I turn the front brass adjuster clockwise or ant...
  24. Replies
    11
    Views
    1,817

    Hi mate", yeah I can relate to what you said...

    Hi mate", yeah I can relate to what you said here. I am riding my RT with DPS light on and have been doing so for nearly a year. Hard to steer at low speed, but OK at highway speed, although...
  25. Hi Guys", just an update on my RT Canam Spyder...

    Hi Guys", just an update on my RT Canam Spyder SE5", I will be riding it down to a dealer in Melbourne in early October to get DPS replaced, 2 new front tyres fitted, front brake pads fitted, brake...
  26. Hi all", I checked all leads ground battery leads...

    Hi all", I checked all leads ground battery leads etc. I put a brand new battery in the Spyder and now at least I have eliminated all but the DPS codes. As I said in earlier post Spyder is booked in...
  27. Hi all", checked the battery under load, and no...

    Hi all", checked the battery under load, and no load did a few things and I made a deciion to book the Spyder in to get it looked at. If it needs a new DPS unit I was quoted about $2000.00 AU for the...
  28. Thanks Peter I got a better idea now that you...

    Thanks Peter I got a better idea now that you showed me. I tested the battery under load and it was 10.12 Volts with a multi meter and over 14.5 volts when running and my battery is under my seat...
  29. Hi Peter Aawen can you send me a picture of where...

    Hi Peter Aawen can you send me a picture of where this is the bolt holding the cable along side the DPS
  30. Hi Pete", I had better try these things you said...

    Hi Pete", I had better try these things you said that you did, and see what happens.

    Regards Peter
Results 1 to 30 of 157
Page 1 of 6 1 2 3 4