Search:

I looked at Copart's website and it looks like they don't sell parts, only vehicles - but thanks Larryda.

Does anyone know where I can buy a used front trunk lid for the Spyder ST LTD from 2013?
The new ones cost a fortune :(

Help please!

Poland is not in the Third World. You may not believe it, but we have everything available here just like in any modern country ...

Hi everyone! Does anyone have experience with fitting 155/60/15 front tires? These tires have a max load of 74 and the original 165/55/15 tires have a max load 75. Can these tires be fitted...

Fault found thanks to your support.:yes: The cause, as usual, proved to be prosaic. I have a non-original belt tensioner in Spyder. This tensioner came loose and his arm hit the lower belt cover. It...

Maybe I wrote it wrong ... I meant that it seems to me that the belt is very tight but maybe it is the other way round and it is not very tight. Then he could jump on the teeth of the drive wheel...

Is it possible that the drive belt - very tight- jumps over the teeth of the drive wheel and does not cause damage to the teeth of the belt?

This was not the case before so this is not normal. I have checked the belt and everything that can come in contact with it, such as a tensioner, but I have not found anything that could cause this...

You are right, BajaRon, so before I get to the valves, I will check the drive pulley and that the teeth will not jump on the drive axle. Thanks

Yes, it may sound like a belt and come from a drive. Adjusting the valves ... this may be an idea because you can not hear this clatter after the engine has warmed up, as well as without load when...

With the tensioner disconnected, it is the same. When I raise the rear wheel and turn on the drive, nothing knocks.

Unfortunately, that's not it. Belt checked, clean, teeth all OK. The clicking sound is heard only at the first, second start (multiple knocks when starting) and then not anymore. Any new ideas?

No, not when changing gear, but during the first meters after moving off

OK, tomorrow I'm checking the belt thoroughly and looking for stones. I will let you know what the result was.

In my Spyder ST, when starting forward or backward, there is a click from the drive belt. Later, when the motor is warming up during the ride, there are no knocks when starting. Any of you have...

The reason for the fault was prosaic. The connector connecting the control on the buttons on the left handle disconnected. Unfortunately, finding the source of the fault was not easy and required the...

The load shedding relay - which is the relay in the box?

I will check the F5, if it has to do with heating the grips. I have fog lights. I will try to disconnect them.
I will also remove R4.

Yes of course, I will connect to the computer and check the errors again

Milk Bars ?! ... it's good for students but it was a long time ago :) With this brake it would be good if Spyder allowed to put the gear on :(
I spent some time in Your country - I also enjoyed it...

Yes, these lights come on normally when the ignition is on.
Battery checked, charged - works well, electrical connections checked and cleaned ... what else, ideas, suggestions.

Works only the...

The diameter 215/60/15 is 33 mm higher than 225/50/15 and the speed at 100 km / h will be 5 km / h higher

Hi, could can anyone help me solve my problem with Spyder ST LTD Y2013? After turning the key on, the start screen appears but the mode button does not work. So I can't start Spyder. Other on-board...