That is a cheap knock off from China. All Show Chrome backrest are made in the USA.
Type: Posts; User: RD2-BBP
That is a cheap knock off from China. All Show Chrome backrest are made in the USA.
The Show Chrome harness connects to the tail light harnesses and that did not change from 2017 to 2018.
The HCL fits the F3T bags very well. With liners it's all about how tight you stuff them.
You can go to Bigbikeparts.com and read the instructions for part number 41-173 and 41-174. That will tell you how to put the light on the bike.
I would look for a M12 hydraulic fitting.
If you use the Show Chrome 13-311 fuse block the relays are built into the box. Then you can add anything you want without an issue.
Yes. That is the number from my BRP fog lights switch.
The switch is an EAO part number 82-5151.2143. 19mm diameter switch.
Try Mouser Electronic #123-82-5151.2143
Hopnel is one of Big Bike Parts brands. Email them at info@bigbikeparts.com
The blue is the running light and the red is the turn signal. You can tap the blue wire into any wire that is hot when the key is on.
The connector should be pushed into the light. the picture you have shows just the led bulb and not the led driver. pull the cord out and you should find the rest of the connector. Look at this and...
If I remember right there is a sheet metal plate on the inside that you can loosen and that will let the bolt come out at an angle.
Does anyone have any idea what is the reason for the vents of both sides of the storage box in the dash? It look to me that they do not connect to anything. Are they just there for looks? I'm...
Lamonsters Garage has them. To mount them you just take out some screws and reinstall them with some little clips. then the nets attach to the clips. Very easy.
Take a look at Show Chrome 13-311. I think it is what you are looking for.
http://www.bigbikeparts.com/templates/product.aspx?ProductGuid=13-311&GroupGuid=16
Right Light 710004033
Left Light 710004032
If the pedal does not stay up you probably just need to bleed your brakes. They should not be that soft.
Value Accessories has them. They look nice but I do think you would want to remove them when its hot.
This Saturday May 21 there is a poker run leaving the Stone Lake Pub at 11AM. The ride is a little over 100 miles and will finish back at the Stone Lake Pub about 6PM. Stamp cards are $15 and...
http://www.bigbikeparts.com/shop.aspx?GroupGuid=16
Your correct. The Big Bike Parts Pedal is 1/8" wider than the OEM.
The Big Bike Parts brake pedal is made just like the OEM pedal and does not raise the pedal at all.
The Ultra Guard cover has a zip out windshield and backrest pocket.
They DOT requirements are for the bike manufacturer only. You can modify your bike as long as you meet the minimum for state laws.
This one mounts on the left side of the handlebars.
If you install a Show Chrome trailer wiring harness and connect any light you want to add to the trailer harness everything will work.
Your Spyder will not know anything as been added because the...
To use a wired headset on a RT you have to have the CB installed first. The RT don't come wired like a Goldwing or a Ultra.
http://store.valueaccessories.net/Multi-FunctionRearLEDTrunkLightCan-AMSpyderRT.aspx
You only have to cut a piece out of the hard plastic filler in the newer seats. The foam in side is already cut back.
Try the Ultra Guard 4-455BC. I know it will fit a ST with saddlebags.