Search:

Type: Posts; User: pauly1

Page 1 of 17 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    57
    Views
    2,899

    Poll: All of BRP's responses are to protect the...

    All of BRP's responses are to protect the company. Yes, the electronic systems, aka "nanny", are calibrated to the OEM tires and stock wheels. Other combinations may work but BRP has not validated...
  2. We have had Kanines on 2 F3s and will address...

    We have had Kanines on 2 F3s and will address your question directly: they are vastly better than the OEM Kenda tires. They wear flat across the face and we're still counting miles at 15K and they...
  3. HowTo: That's well and good to try to be precise....

    That's well and good to try to be precise. However, if one tire is setting in the sun, guaranteed they will not be at the same pressure as soon as you turn it in the shady side. I'll wager that there...
  4. Adding to PMK's post (but not copying its...

    Adding to PMK's post (but not copying its entirety), I define "spirited riding" as reaching the point of breaking friction with rear tire is a corner (a slight drift is noted), or constantly running...
  5. Nylon 6/6, polyamide 6/6, is a general purpose,...

    Nylon 6/6, polyamide 6/6, is a general purpose, semicrystalline plastic. It has excellent temperature range performance and high chemical resistance. It also has low surface energy, minimizing...
  6. Replies
    3
    Views
    778

    [SOLD] Still looking. Wayne

    Still looking.

    Wayne
  7. Good morning, Lamont and Joan, The link in the...

    Good morning, Lamont and Joan,

    The link in the lead comment of this thread takes me to the 2023 raffle.

    Congratulations on securing the raffle again this year!

    Wayne
  8. I made a converter plug/extension to go from the...

    I made a converter plug/extension to go from the bike 4-pin square socket to a Bushtec 6-pin. One just needs to understand the lighting circuits. The BRP harness comes with a power shedding relay so...
  9. Once the back end is up, off the ground, one can...

    Once the back end is up, off the ground, one can use an inspection mirror to view the tire faces. Less bending and you won't have to lift the tire so high. The plastic fender inhibits access to the...
  10. I have a set of Givi Monokey Trekker boxes on my...

    I have a set of Givi Monokey Trekker boxes on my 2015 F3-S. I made the mounts, design based on the F3-P police F3. It is set up for solo riding.
  11. If pressed, tell them it is a custom vehicle with...

    If pressed, tell them it is a custom vehicle with "J" style rims.

    I've had tires mounted and balanced at a local Discount Tire in Stillwater, MN. No questions and the manager even thought the bike...
  12. The whole MC argument is based on the "dark side"...

    The whole MC argument is based on the "dark side" of using automotive style tires on a 2-wheel, leaning motorcycle. If I bought tires for the rear of a Harley-Davidson Tri-Glide, would they use the...
  13. Replies
    3
    Views
    778

    [SOLD] Thank you, Peter, for the reminder and bump! ...

    Thank you, Peter, for the reminder and bump!

    Wayne
  14. Replies
    5
    Views
    404

    [SOLD] Pending....

    Pending....
  15. Replies
    5
    Views
    404

    [SOLD] Only what it costs me. From zip code 76087, and...

    Only what it costs me. From zip code 76087, and via USPS Priority, it will fit into a Medium box and would be about $17. Shipping via ground, would be a bit less, and goes from 2-day to 4-day...
  16. Replies
    5
    Views
    404

    [SOLD] BRP Storage Cover - GS/RS/ST

    BRP Storage Cover BRP# 280 000 338. This is a full cover to protect the bike from dust and debris. Breathable knit material, of 95% polyester/5% cotton mix.

    Will fit GS and RS with stock types of...
  17. Finally took the time to create a dual boot on my...

    Finally took the time to create a dual boot on my MacBook Pro with i7 Intel chip (2017 release). Using Bootcamp, created 64GB partition on internal SSD drive, loaded Win10, loaded BUDS/BUDS2 software...
  18. Looks intriguing. Although, it doesn't seem...

    Looks intriguing. Although, it doesn't seem plausible that 500 hp can be put to the ground using that chain in the final drive. Or perhaps it's change 3 chains per tire change, but then there will be...
  19. Replies
    2
    Views
    594

    [SOLD] Located a bar. Thanks for the replies! Wayne

    Located a bar. Thanks for the replies!

    Wayne
  20. Replies
    2
    Views
    594

    [SOLD] RT 2015 or newer OEM BRP Anti-Swaybar

    Seeking a 2015 or newer (anti)sway bar torsion bar, original equipment from an RT. It must be from an RT. If you put a BajaRon bar and have your original laying around, I'm interested. Most often the...
  21. Replies
    3
    Views
    778

    [SOLD] F3-T or F3-L OEM Primary Muffler

    Looking for an OEM Primary Muffler for an F3T or F3-L. Model year 2018 through 2023. Can-Am part # 219800442. That's the black one that mounts below the RH Side Case. Preferably in the Dallas-Ft...
  22. Replies
    2
    Views
    834

    Yes, I have done that surgery. It's been a while...

    Yes, I have done that surgery. It's been a while ago, so I don't recall if I kept photos. From the inlet, the exhaust enters a chamber the full dimension of the muffler by about 3" axial depth. Then...
  23. Anyone with '20+ Spyders tried Front Fender Lighting fm ShowChrome & TricLED?

    We are in the process of adding a '23 F3-L to the stable. The trade-in is a '18 F3-L that had Custom Dynamics Brightsiders in both the side and rear-facing positions. We have other F3s with...
  24. Having read through the thread, your fix was...

    Having read through the thread, your fix was going to be my recommendation (as I had just completed the same on our F3-L preparing it for sale). When the wheels are aligned, laser or otherwise,...
  25. I have used Lamonster mini's and now have the...

    I have used Lamonster mini's and now have the long foot boards on my 2018 F3-T. I do not notice any extraordary vibration through them. The OEM style of footpegs, which came on your F3-S, had rubber...
  26. Replies
    26
    Views
    2,475

    First, thanks, Peter, for explaining a search...

    First, thanks, Peter, for explaining a search method: "rear sprocket", for me, did not yield useful information.

    r.e. changing sprockets. The on-board electronics, ECU, TCU, etc, are generic until...
  27. Replies
    26
    Views
    2,475

    Change rear sprocket from 79 to 89 tooth on 2023...

    Change rear sprocket from 79 to 89 tooth on 2023 F3-L

    I tried to search but didn't find any significant result. Can the sprocket and belt be changed without the nanny complaining? I know about ECU...
  28. Replies
    8
    Views
    767

    I replaced a front bearing cartridge on my 2015...

    I replaced a front bearing cartridge on my 2015 F3-S, not due to bearing failure but changing out the spindle. I was trying to troubleshoot a brake run-out / wheel flange run-out. But the bearings...
  29. [SOLD] FWIW, I know the owner and she took great care of...

    FWIW, I know the owner and she took great care of this machine.
  30. Replies
    34
    Views
    3,096

    Before I read or watch any review, I check the...

    Before I read or watch any review, I check the credentials of the individual or firm providing said review. Then I can decide on the validity or truth in the review. Some just want to be an...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4