Search:

pm sent.

I must admit I'm confused. I did the search about exhaust options for the Spyder and HMF came up quite often as the best bang for the buck. When I went to various sites I came up with several...

From what I see, it's not clear if ST parts fit RSS? Evidently there was some changes from years '12 and before and '13 and '14. Still don't understand why I can't pull up the HMF site(s).

For some reason I can't pull up any of the hmf sites. Does anyone have the part number for the above bike? Amazon and ebay are not clear on years and models. Thanks for any help.

Keep in mind it will almost certainly have a salvage/reconstruction title even with new frame.

To add to the situation, ohm resistance on the rear (lean cylinder) plug wire is >3,700. The front wire (rich cylinder) is >6700. It's above my pay grade as to whether this is reasonable based on...

Today I pulled the plugs, the front one is about much fun as I could stand. The rear cylinder is running very lean, the front is running very rich. I ordered plugs and wires from Bajaron, but will be...

The saga continues! I took the Spyder to the dealer and they cleared the check engine light. They told me that to take it out and ride about 20 miles or so for the computer to reset. At about 3 miles...

Will do. Thanks

I forgot to mention I also replaced the two vacuum lines first thing when it would not idle smoothly. There wasn't any cracks, but figured it's easy enough to do. It's my understanding that once you...

A little history, several days ago I bought the 2014 with a little over 3K miles. It would not idle correctly and had the power of a moped. In a previous post you riders were kind enough to give...

Snowbelt Spyder, appreciate stepping me through the the steps to pull up the code. Results were P0131. According to what I could find my issue is possibly the O2 sensor or a connection problem with...

No I haven't, I have a tech manual on the way. Does the dealer have to pull up the codes?

Wanted to get back to you riders after doing the following: checked air cleaner and snorkel all was good, replaced the two vacuum lines with the NAPA high temp. silicon tubing, disconnected the...

Sure appreciate the suggestions. Just found out I will be out of town for a couple days but will follow up when I figure it out. Thanks again.

Upfront I apologize for my first post to be question, but will get to introduction post ASAP. Now to my problem; I just purchased the Spyder and it has not been ridden alot. Being a 2014 with only...