Greetings, I recently purchased a 2010 Spyder RSS it only has 3200 miles on it but it is been sitting in storage for over six years. Other than the obvious things: tires, oil change, check fluids,...
Type: Posts; User: Kilroy
Greetings, I recently purchased a 2010 Spyder RSS it only has 3200 miles on it but it is been sitting in storage for over six years. Other than the obvious things: tires, oil change, check fluids,...
I have not found the COG group to be very inviting, they seem to me like those stuck up Harley guys LOL
That is my 2015 Ultra Limited in Radioactive Green ;-)
Sorry to be leaving so soon, but unless I really love a bike I am always on the lookout for my next. I have a 2015 Harley Ultra Limited that is proof of that. I have enjoyed my stay here and I...
Welcome to the family!
I figured it was the way it was but after not riding it for a week due to a trip we were on, the first day back I rode it and I was like, this is not my Harley LOL When I first got it I rode it every...
Coming from years of riding Harleys and even the VROD, when I started riding my Ryker (Home from the dealership some 120 miles) I notice that I get bobbed left and right while seemingly going in a...
+1 for Progressive
I was on my Harley, I followed my friend riding the Ryker ;-)
Thank you for that!
Agreed
Agreed, the Rotax motor is happy at high RPM. Speaking from being a Snowmobile rider with the same motor. If you have seen up close (outside the vehicle) either the Ryker or a Snowmobile muffler you...
Installed Show Chrome Command floorboards and brake pad purchased from a fellow member here. Thank you!
Nicely done! I am considering just removing the battery (easy enough to get to) and bring in the house and put it on a tender to keep it out of the cold. Not quite as easy to do on my Harley.
My friend and I took a ride and I followed him on my Harley and watched as he turned different directions while braking and it all looked fine, the short flashes, then the long flashes then full on,...
The flashing pattern only runs for a few seconds then they go solid. If the turn signal is going then that will continue to flash afterwards.
Here is a “crude” diagram I drew up of what you can do if you wanted to make up and use factory connectors to do the same thing I did:
192109
Keep in mind if you choose to do it this way and place connect at the light, you will need "two" modules. You could get creative though and use 4 connectors and join the white wires on one side and...
Are you just allowing "gravity" to contain the saddle bags in place or do you support them at all to prevent them from moving. I like this! I am using the small LinQ bad for now but I may if I take...
That will be a lot more work. I am not really sure why you would be apprehensive about cutting the wires. There are "splices" everywhere in the harnesses and of all things they TAPE everything with...
Installed a brake light flasher:
https://www.spyderlovers.com/forums/showthread.php?143682-Inexpensive-brake-light-flasher-with-photos
The commonalty available GS-100A brake light (LED) flasher can be wired into the Ryker's electrical system if you are not squeamish about cutting into your wiring harness. The white wire that goes...
Got it thank you!
https://brpmanuals.com/
Guess I am dexterous enough it took me a couple of tries and I got mine in with my fingers and a little pressure from pushing the bolt in. I saw someone using a bread tie to install them.
I am looking at doing a few projects to my Riker and I’m wondering if anybody has access to the wiring diagrams for them?
I believe it will be stock on the Sport and Rally but an add-on for the 600/900 Ace. I called and spoke to BRP support and they could not commit to saying it could be added to models before 2022...
$80! :-O did they make a big diff over the original Rally shocks?
If they are the black ones I will take them.
Hard to tell from the photos are these black ones?