Search:

It also shows that the idler is mounted in a different spot than before. It's now mounted further back and on top of the floorboard mount.

This outfit may have what you need.
www.scratcheshappen.com


Change from Auto to Motorcycle and input your year and model. I have gotten both color repair kits for our 2018F3 and 2020RT.

Been in the 90's all week and into next week. Haven't been able to ride much due to the home remodel, but plan on riding this weekend. Looking forward to seeing friends in Serri Vista, AZ!

On my wife's 2018 F3L the GPS connections were on the left side under the panel just below the tank close to the driver's seat. They were zip tied to the wire bundle. Look for the two wires not...

Monk,

When you replaced your front tires with the Q5's did you notice a smoother ride? When I did that to my wife's 2018 F3 I asked her how it felt. She said like a new bike that is so smooth that...

Which wheel are you looking to carry?
The front or the rear?
You would need to carry both to make sure you are covered plus a jack and braker bar with socket. That's a lot to carry.
I was part of...

Same colors, except for the Sea to Sky model.

I installed helibars on my 2020RT and I needed to pull more cable to do that. The wires are long enough - you just need to find where they are tied to the bike and clip the plastic wire ties.

Not able to read your attachment. I would be surprised if your valves needed any adjustment as I haven't read of anyone that has - even high mileage Spyders.

I also needed a puller to get the pully off. No need to purchase one as most auto parts stores have a free tool rental program. I just went to the closest one. In my case an AutoZone and browed their...

The new front sprocket is 705503239. This is the white one that came out after September 2020.

The oem pads have grooves cut into them and as long as you can still see the grooves you are good. Easy to see that from the side of the calipers.

I wonder what they did at 600 miles since the first service is at 3000 miles? The twins were 600, but all the triples are 3000.

BRP changed the front drive sprocket in September of 2020. If you get a 2021 made after that you should have the new sprocket that is designed to eliminate the noise. If unsure have the dealer check...

1 7/8 fits all Can-Am trailers

Not if you keep the ratio close. Look for total tire diameter when comparing tires. Since the speedo reads from the rear wheel it's not as sensitive to the front tires. I have had no issues going...

They will, but the fronts are 15" as compared to your 14". If you were planning to swap tires the fronts will not fit. Rear is the same size.

Looks like your issue is the trans side drain plug as you can see in that picture oil on the plug.

If you feel comfortable removing your rear wheel you can take it to a tire shop and have them mount the new tire. On our last trip my OEM tire was bald 500 miles from home. I stopped at a BigO tire...

I found this out the hard way. On our 2014 I attempted to push the piston back with a large C clamp. This resulted in damage to the screw adjuster, and a new caliper.
Since then I purchased Ron's...

You need to add the rim blades to your web site. I went to check them out - but nothing listed,or shown.

If you can't find a used one- looks like you can still order a new one for around $410.

https://www.cheapcycleparts.com/oemparts/p/can_am/705009068/hood-full-moon

https://tricledusa.com/collections/spyder-rt-2020-everything-else/products/spyder-2020-rt-s-wide-vu-mirrors

Milryder,

What I would do is once I pick the trim level I want get a price out the door from your dealer and a price from IMotors. If IMotors is less go back to your dealer and tell them you...

100% agree. We have both and the F3 is a PITA

Interesting as I am running a 205/65R-15 on the back of my 2020RT with no issues. My speedometer is now within 1/2 mile of my GPS.

2014 rt traded in at 84,000 miles with no pully issue
2015 F3 traded in at 56,000 miles with no pully issue
2018 F3 at 33,000 miles started nearing a noise pulled the pully cover and found red...

M6x20 available a hardware store

Went for a nice ride with the Can-Am demo team out of Nash Powersports in Masa. Since they had more riders signed up then the Spyders available I rode my own 2020 RT. Temps in the 70's and a great...

I installed a set of Baja Ron's front shock adjusters to my 2020 RT. Did two turns and it really tightened up the handling.