Search:

As stated in post #2 .... 2014 RT .....Mike :thumbup:

I'm Mike (the BLUEKNIGHT) who "chopped up his airbox" - but that wouldn't be my terminology for what I did. I removed the plastic intake plumbing to the Airbox (including the rubber Elbow) and...

The WHY they don't may be as simple as this ..... When you are in your car, it's enclosed ( or can be ) so you can heat the air or cool it .... you don't have that option on any Mtc. .... I don't...

I have a 14 RT and it has always read 2 to 3 high ......I think they all do, based on numerous comments in the past 10 years .....Mike :thumbup:

Have you checked your owners manual ????? ...Mike :thumbup:

:roflblack: I'm really glad you are concerned for the safety of my plywood ....... You are one of the reasons that make this forum a fantastic resource for all us morons here ..... have a great day...

It's model # 44 UL09 was $20.95 @ Amazon with free shipping. Crutchfield has it for less but no free shipping. The Metra is relatively short, so you only need about 8 inches of space below the...

Waaaaaaaaaaaaay back over a decade ago, I bought a replacement seat cover for an '08 GS seat - didn't get to use it ..... I have a 14 RT with over 81000 mi. and there is some slight cracking in the...

Well about years ago My OEM antenna broke, so I decided to prevent that from happening again. I bought a manual retractable auto antenna, and last year that broke also (my fault, it was fully...

:hun: ....If you are getting lots of water in the rear trunk .... you should get that fixed ..... I don't have that problem ....Mike :thumbup:

About a Turkey ...... last time I was down that way ... on the way to Peel's ferry .... a Turkey flew off the side of the road I was on and managed to get between me and the windshield ....almost...

A lot of folks here (me included) just added a small FUSE box connected to the battery and used that as needed. I think I paid $8.00 for 6 circuits .... see what "Banggood" has to offer. .... Mike...

Got a few here in Vermont near me ..... even a Round Church .....Mike :thumbup:

Look at what "iMotorsports" (a site sponsor here) has - they will ship most Spyders for free .... Mike :thumbup:

I made my own from a pattern that " safecracker " sent me..... a used a piece of 1/2in. plywood .... drilled a hole in it. and put the bolt that is used in the hinge on the other side..... Yes it's...

I have a 14 RT also - my understanding of how the brake works is that there is normal braking and there is "balls to the wall Braking" .... in the latter mode, the floorboard is supposed to tip...

:agree: with Peter ( above ) ..... when BRP came out with the F-3 model .... as far as seating positions goes that was a major change .... other than that all the other Spyders are basically the same...

T-6 is a Full synthetic .... I don't think they will thicken in cold temps like a dino oil will ....JMHO ....Mike :thumbup:

:agree: my 14 RT is similar ..... I had some scrap plywood 3/8, I drilled a hole one inch from the end then made two cuts alongside the hole ..... this slot fits over the oil filler and makes it easy...

Here in central Vermont the near term weather is going to be in the low to mid 80's :clap: ..... with mostly sunny ..... generally speaking 80's in May is not normal ..... but I'll take it .....Mike...

:agree: with Peter and Snoking 1127 ..... The actual bed size is only meaning-full if the tailgate opening is wide enough ..... And a short ramp isn't really a problem - just tilt the TONGUE end up...

I have over 80,000 miles on my 14 RT, which I bought and have DIY serviced since new - only 40,000 miles on a 1330 engine is nothing to be concerned about. You don't say how much they are asking, and...

I know many folks here were/are using straps over 2 or 3 tires .... I only ever used one over the rear tire and never had an issue .... My front tires had blocks on the outside of the front tires...

I have the same engine/trans that you do .... a 14 RT with 80,000 + miles .... on a cold start the revs are 1100 + rpm's and they drop to 900 in about ONE minute ..... this lowers the CLUNK quite a...

:thumbup::thumbup: .... that's on the left as you Face the Spyder :roflblack:.....Mike :thumbup:

You have an older Spyder and I don't know the Sequence of button pusing for retrieving codes. ....My 2014 RT is different. Someone will chime in and tell you ..... However you might try this ........

:agree: :clap: .... I started ( this method ) using rachet straps over the wheels / tires about a decade ago. There is no better way of preventing your Spyder from moving - PERIOD..... It's simple,...

The OEM front speakers were 5.25 .... the rears were a custom size, I think 4.25". I was able to enlarge the rear hole to fit the 5.25 without any problem .... A tip .... if you can raise the speaker...

When you get to that area, check out the Chamber of Commerce roadside stands .... they have maps of the local area's best MTC. routes ...... Enjoy Bruce ....Mike :thumbup:

I did mine completely differently.... The output of the OEM stereo/amp is fine; the key is how much resistance the Speakers have. OEM, that is 4 Ohms; mine are 2 Ohms. My '14 RT can be heard from 300...