I agree with trikermutha. The best way I have found to stop the buffeting into the wind. is to install the 2 inch shorter vented windshield. The vent is the key! Made a world of difference on my 2012...
Type: Posts; User: brrujo
I agree with trikermutha. The best way I have found to stop the buffeting into the wind. is to install the 2 inch shorter vented windshield. The vent is the key! Made a world of difference on my 2012...
Its a major job! Sounds simple but it is far from it. I have done it, but I will tell you I would not do it again. Check out the chrome handlebar covers offered on Ebay. I have seen them and the look...
Correct. Vacuum hoses and plug wires. Was all covered under EPA warranty. Thanks for all your input!
I am taking bike to dealer this week. Any ideas before I get there? Bike has 3800 miles. Rode it yesterday and it acts like it is only wanting to run on one cylinder. Then all of a sudden it will...
I am taking bike to dealer this week. Any ideas before I get there? Bike has 3800 miles. Rode it yesterday and it acts like it is only wanting to run on one cylinder. Then all of a sudden it will...
My wife and I will be there. 1 Spyder
For sale: 2 (two) Can Am part # 447380090 Helmet Headsets. Retail 159.99 ea. Also includeed is the J&M Lower 8 pin cord with Vol and PTT control for passenger. Retail 119.95. Total retail 437.00
...
WTB One chrome wheel for 2012 RT Limited. Cam An # 219400256
+1
Bought mine new in 2012 for 25800. I agree that it seems to be the best year. Trouble free!! I would think 18-19k should buy it
Thanks Bob for your help. Seems pretty simple compared to installing the CB which I did. I was really hoping not to go through that drill again!!
Are you going to Spyder Fest?
Bob,
Thanks for the help. No XM. I built the harness you did the video on. So it just a matter of unpluging the CB from the radio ??
So with all this, I still have a question. My 2012 RT has a cb. It doesn't work worth a damm and never has. I would like to install the Sena system. I can see that the dongle harness goes where the...
I have a reservation for one room at the Comfort Inn in Ozark for May1 through May 4 that I will not be using. I am going to sit on this for a few months before I cancel. If anyone needs it, I will...
Still not sure...Is it my understanding that you either have blurtooth or CB, but not both??
Just got mine. Waited 3 months. Well worth the wait. Very nice rack. Only issue if if you have the rear upper brake light (as I do) you will need to get two .5 in x.5 in od spacers to go under the...
Just installed Ron's sway bar on my 2012 RT. Took a ride to the Texas Hill Country. I had to get off the Spyder now and then to make sure I was riding the same bike!! What an incredible difference!!...
I installed a set of Seal floorboards on my 2012 RTS. Love em' !!
Got to rub the dash with rubbing alcohol before you stick it on. That's the way I did mine and is is really stuck!!
Just recieved mine yesterday. I will give it high marks!! My Glock 36 fits perfect in center pouch!! Good quality. No view obstruction. Takes about 30 seconds to install!!
Got em, Love em, Easiest accessory to install on Spyder Rt so far. 15 minuites.
Cowtown Powersports Fort Worth, Texas
Good luck so far...
For an RT or RS?
I put the "Seal" floorboards on my 2012 RTS. Very pleased. Don't see how it could get much better.
Just installed the BRP CB in my 2012 Can Am. Not a big CB user but wanted the intercom feature. Everything works great with the exception of the CB. Range is about 500 ft. I suspect it has something...
Same issue on mine. It is the brake pads. Should go away in a mile or so.
Thanks! Thats it.
What is the link? I have always thought this machine needed a larger pedal.
I also have the issue on my 2012 RT. 70-80 MPH. Very annoying. BRP can say what the want, however if this is "normal", they need to go back to the drawing board. I have ridden belt drive Harleys for...
After much deliberation and a fair amount of confusion I opted for the Seal floorboards. www.sealfloorboards.com They install very quickly (less than 30 minutes) and look great on the bike. Makes for...