Search:

Hey Don. The closest thing I have to a 2011 is a 2013 manual, so here's what I know. You are correct in that the cluster operates the turn signals. Now, the difference between the turn signal switch...

A shield around the switch would pretty much defeat its purpose. Besides, now that you’ve done this once, you’ll never do it again. But, maybe consider putting your bottle holder on the left side.

Well, of course you don't want to have your phone next to the key when trying to start. but DESS doesn't put you into Limp Mode. It just prevents a start. Are you certain the it is Limp Mode? If so,...

Sorry Dan. You can’t deactivate DESS on a 2011. Only 2014 and newer. Why? Is something going on now, or just looking ahead for prevention of future problems. You can rest easy, though. That first...

And Martin, the bar end caps for the 2024 have a new and different part number than the others. I suspect that when they say 2013 and up, that they haven't updated that info for awhile. Maybe foam...

Hey T. By law, ANY factory authorized dealer/service department must honor a factory warranty. I doubt IMotorsports is an authorized Service Department. So, like Clover Hill said, go to the local...

Regardless of whether your front turn signal lights are in the mirrors, or on the front fender tips - they made the change somewhere around then - they are already LEDs. A sealed unit. Not owner...

Or….Dan, you could put in the same bulb type, but the ones with built in resistors. I trust you saw how old that video is. Resistor bulbs for these types of applications are more readily available...

Hey Deme, after I made that post back then, Billy hosted that document on his Google Drive. It’s still there. Go back up this page to post 11. Click the link, the document will open, and you can down...

I assume you know that on a Spyder, the ABS unit isn’t just an ABS unit. It is the Vehicle Control Module. One of the black box computers in the system. Occasionally they do go belly up suddenly....

The cable that locks the glove box? What does it do? ...well, Jack, it locks the glove box.

It's like this. The handle bars on a Spyder will lock, just like other bike's do, except it doesn't have...

Yes, he was mistaken. And that's how drain plugs get stripped out. Clearly a Torx - T45 - and clearly an Allen - 6mm. Otherwise referred to as a hex bit.

Hey Mark. Yeah, this failure is not common at all. You’re only the third one I remember seeing on here in 12 years. If it wasn’t for that, we would have never heard about it, either. Glad you found a...

If you don't want to hear the alarm when you turn the key off, then don't turn the key off. Just kill the engine with the Kill Switch. How long does it take you to check tire pressures, anyway....

Hey Mark. Well, your SE5 clutch is nothing similar to an SE6 clutch. So his problem with a loose nut doesn't apply. Those two clutches don't share any DNA.

Unfortunately, I'm sorry to tell you...

So, I'll give you some 2023 info that should (I hope) be good for a 2022. You want power up front in the frunk, right? Look in your frunk on the left hand side of the battery access panel, and see if...

Well, Dog..I’m just going to have to give it to you straight. I’m sorry if I sound mean, but except for the legacy issue of your center display not working, everything else has been self inflicted....

Thank YOU for following up. Get out there and RUN it. Watch out for deer.

Yep. The 21+ Spyders DO handle better with the OEM bar than did their predecessors. Ran Ron's bar on the old 2012. Ran the OEM bar on the '23 all last year. Put on Ron's Original Bar just a few days...

Actually Yes, the fuel trim setting DID have to re-adjust once you reconnected the hose, and the additives can help, too. Go back and check on what size ID hose that you used when you replaced the...

So, System Too Rich on both the front and rear cylinders at the same time. Doesn't happen very often. Usually it's a lean issue, not a rich issue with this thing. Did you pull those codes while the...

I understand, Tony. But there usually isn't just one thing. The ECM is pretty good at telling you if there is a bad sensor. They all have signal too Hi/Lo fault codes.

So, Here’s your To Do List....

Why do you think that? Do you have a code? Do you have any codes?

So, you had a low fluid level and did a brake job. Then AFTER the brake job, you got those two codes and are wondering if they can be caused by low fluid level. Well, most folks top off the fluid as...

That’s just not true either, Dog. Every time you or the computer shifts the SE5 gearbox, the Hydraulic Control Module momentarily disengages and reengages the clutch. You’d have to be pretty good at...

For smg323 - Don't know if you'll ever get back to this thread, but I'll answer it with pictures and send you a PM letting you know. Maybe someone else is curious, too.

I respect that you believe...

Water in the gas causing the engine to die I get. Causing a U0155 code? A connection I never would have made. Shows how much I know. Glad you’re back on the road. Be safe. Watch out for dillos.

Friends...we need to keep in mind some forum awareness, on just how confusing this topic is becoming. All because of the word "CarPlay".

This particular thread is about, and has always been...

Maple replied to you in that other thread. Yeah, it’s getting confusing. Short answer, No. there’s no app. It’s part of the vehicle’s electronic package. Once they get connected, the iPhone and the...

CarPlay

Just watched Smoak’s vlog from yesterday. According to him, BRP hasn’t received their licensing certificate from Apple, yet. I guess they shipped the machines anyway. However, the update...