Search:

The throttle on my 2015 F3S is just like yours and had from new a short delay. I fitted a pedal commander and it solves the problem and is absolutely awesome

Looks like that pulley may be very hard to remove.

Interesting post as I think these are the three pieces you need to remove to change the belt on the left hand side of the trike. Hope someone chimes in to answer your post but I personally do not...

Hi

In answer to your question here are the rear axle torque specs for Can Am Spyder GS/RS

96 lbf.ft or 130 N.m

Probably because it's a little hooligan. I also have a F3S but the Ryker is a whole different thing.

I Agree. Can't imagine why they have not but maybe it will come.

Good shock loads of adjustment maybe to much, Pre-load, Fast/Slow Compression & Rebound. Still going out and tweaking settings a bit.

Bought a full set of Progressive shocks for my RS and...

Converted my European spec F3 to a chopped fender and did away with our silly indicators on stalks151965151966151967

I also own 2008 RS and about 8 months ago I got an error message which on looking at the codes was something like Stage 2 coil failure. Checked spark on no 2 cylinder and sure enough no spark....

I have both a 2008 RS & F3S and both are fitted with smoothspyder belt tensioners from capt Jim. The first was bought a few years ago after I got fed up with the vibration on my RS and it solved all...

I have had a Blue Ridge with and without a MRA Xcreen Touring deflector attached, a Gustafsson and now a Madstad. The Blue Ridge with the Xcreen helped but I still got wind blast on the head at...

I bought a set of Attitude handlebars and there is for me a major problem with them. The bars on full lock touch the fuel tank paintwork and may/will mark it over time. I took mine off and reverted...

I am 5ft 10 1/2 inches with a Blue Ridge fitted to my F3 and the wind hits my helmet. I also have a Spyder RSS with a Madstad fitted. The Madstad does the job very well but it does move about...

In my opinion Custom Dynamics are the best as they are elbowed. They raise the height of the mirrors & extend them out at the same time. Will give you a great view of behind. I have had them fitted...

There is a map for Two Bros Dual & green (high flow) filter. I will e-mail it to anyone that wants it

Have you still go a map for this as i need one as just purchased JB Pro and have to same setup as you

My e-mail is: richard@harrison-oils.co.uk

I ordered this product a few months back and it took some time to arrive. When installing the knee panels make sure you clean Spyder panels properly.

Install the carbon knee panels then heat then...