Search:

Type: Posts; User: ARNIE R

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    7
    Views
    162

    Before I installed my heated grips, I had...

    Before I installed my heated grips, I had previously and successfully used the wire harness in the nbr 2 position to power a USB and 12 volt accessory port. I have since moved them to the nbr 4...
  2. Replies
    10
    Views
    355

    Had a 650.....loved it until the accident.

    Had a 650.....loved it until the accident.
  3. Replies
    20
    Views
    834

    Yes, same info here. Too much up and down...

    Yes, same info here. Too much up and down shifting between 5 and 6.
  4. Replies
    20
    Views
    834

    Not bad so far. I am used to my older F350 with...

    Not bad so far. I am used to my older F350 with the V10 engine and 4.30 rear axle which could tow anything without breaking a sweat. The new Tacoma does well so far except for a little more...
  5. Replies
    20
    Views
    834

    No real details on the ramps construction. As a...

    No real details on the ramps construction. As a woodworker and handy with tools, I threw them together in about and hour. Sanding, painting, and water-sealing them took longer.
  6. Replies
    20
    Views
    834

    Bought the Bri-Mar trailer new at $1300. The box...

    Bought the Bri-Mar trailer new at $1300. The box up front holds trailer chocks, tie-downs, jacks and other misc junk. The ramps get put into the bed of the truck when traveling.
  7. Replies
    20
    Views
    834

    As long as you have the V6....wouldn’t try it...

    As long as you have the V6....wouldn’t try it with the 4.
  8. Replies
    20
    Views
    834

    It does well. Used it 3 times in 18 months to...

    It does well. Used it 3 times in 18 months to round trip to Florida and back and towed, loaded, and unloaded well. Getting ready to leave next week for FL to deal with some parental medical issues...
  9. Replies
    20
    Views
    834

    My Spyder hauler

    Just a few pics to show my trailer set-up for hauling the Spyder. Just a regular 6x10 landscape trailer with a standard 4 foot gate. Of course, the 4 foot gate and its angle did pose a problem for...
  10. Thread: Oetiker Clamps

    by ARNIE R
    Replies
    22
    Views
    718

    Take them all off and throw them away.....they...

    Take them all off and throw them away.....they leak like crazy and I have already replaced most of them with regular screw-type clamps.
  11. You called that one right on!

    You called that one right on!
  12. I tried so many ways I can’t remember all of...

    I tried so many ways I can’t remember all of them. The most difficult part was trying to get them back into the holes to tighten them back up. My fat fingers keep losing grip on the Allen wrench and...
  13. Another zinger for the Spyder engineers......

    So, Last week, I finally installed my BRP heated grips onto the bike since I was doing some other wiring mods inside the guts. All was crystal clear and easy except the part where you had to remove...
  14. Replies
    10
    Views
    721

    And she did that very well!

    And she did that very well!
  15. Replies
    10
    Views
    721

    The "total" stop only seemed like a very fast and...

    The "total" stop only seemed like a very fast and split second. Since my hand was still slightly partially on the throttle, the bike picked right back up. i think I was was just being a little overly...
  16. Replies
    10
    Views
    721

    Nannie got me real good yesterday

    By now, I am used to Nannie kicking in here and there in small reminders whenever I get a little stupid.

    Yesterday I was making a right hand turn a bit more than extreme than usual. All three...
  17. Thread: Mirror

    by ARNIE R
    Replies
    7
    Views
    709

    Yes, that top clip is the weakest link in the...

    Yes, that top clip is the weakest link in the system.
  18. Thread: usb charger

    by ARNIE R
    Replies
    4
    Views
    543

    I just tapped into one of the ignition on hot...

    I just tapped into one of the ignition on hot wires underneath the console switches
    171990
  19. Thread: Shift Shudder

    by ARNIE R
    Replies
    12
    Views
    576

    I just start mine up while I am putting on my...

    I just start mine up while I am putting on my riding gear and hooking up the phone and GPS. About 3 minutes and all is good.
  20. Replies
    10
    Views
    542

    Pics and updates please!

    Pics and updates please!
  21. Replies
    37
    Views
    759

    Absolutely.

    Absolutely.
  22. Thread: Mirror

    by ARNIE R
    Replies
    7
    Views
    709

    Bottom piece looks like it is in place. The top...

    Bottom piece looks like it is in place. The top looks like it is being "pushed" up. Make sure the wiring harness is sitting inside properly. It is a tight fit, but if it isn't laying down correctly,...
  23. Replies
    4
    Views
    486

    Hoping so....I have secured primer, Cognac Paint,...

    Hoping so....I have secured primer, Cognac Paint, and clear coat and want to repaint the side bag covers (awful factory job) as well as the dash trim panel.....tried to paint Poly-p in the past with...
  24. Thread: Parking Poll

    by ARNIE R
    Replies
    28
    Views
    1,074

    Wouldn't dare park anywhere where a Harley...

    Wouldn't dare park anywhere where a Harley does.....already heard enough about getting a "real Motorcycle"........
  25. Replies
    4
    Views
    486

    ABS or Polypropylene

    Does anyone know for sure if the dash trim panel around the gauges is either ABS or PP? I have examined it very closely and cannot tell which it is. Usually, the type is molded into the back with the...
  26. Replies
    8
    Views
    536

    Headlight bulbs in the ST-S

    To the BRP Research and Development Department, or whoever designed the replacement procedure for a headlight bulb, what were you thinking?

    Got the Spyder home yesterday and noticed the left low...
  27. Replies
    19
    Views
    1,288

    Finally back home in Virginia. Got Mom into a...

    Finally back home in Virginia. Got Mom into a better rehab facility.

    Anyway, back to business. I picked up the Spyder from the dealer yesterday. All seems good now and I certainly hope it stays...
  28. Replies
    19
    Views
    1,288

    Follow-up. Still down south in Florida...

    Follow-up.

    Still down south in Florida dealing with the medical issues involving my mother.

    Received a call from the dealership yesterday advising me that the needed “parts” finally arrived...
  29. Replies
    19
    Views
    1,288

    Yes, that was my original way of thinking about...

    Yes, that was my original way of thinking about it when it happened. However, since it was towed under the BRP Roadside Assistance program, I left it at the dealer to be absolutely certain that there...
  30. Thread: Go Pro

    by ARNIE R
    Replies
    22
    Views
    980

    Helmet mount on mine - works great.

    Helmet mount on mine - works great.
Results 1 to 30 of 194
Page 1 of 7 1 2 3 4