Snow is melting.
Almost time to get out of storage.
Type: Posts; User: ris
Snow is melting.
Almost time to get out of storage.
Thank you for your interest in my Spyder. The way winter is going here in New Hampshire it probably won't be out of storage until April.
Spring is coming.
Still for sale
In storage for winter but still for sale
Any one interested before I put it away for winter?
Bump up
2015 RTSE6 Circuit Yellow, Please read entire ad, Baja Ron sway bar installed, (original included) Speed bleeders, Magnetic mirror mounts, Spot mirrors, Front sprocket recall done, 2 keys,...
Have not gotten the error yet. Trying to be proactive and avoid future problems.
I have a 2015 RTSE6. I am looking for the procedure to turn off the DESS. I have someone with BUDS and a MegaTech license, but they cannot figure out how to do it. Does anyone have the step-by-step...
When I had an electrical issue on my spyder. I copied my downloaded repair manual to a thumb drive. Then took the drive to a copy center. They printed me a 36 by 48 copy of the page I needed. I think...
Try a booster pack on the battery
No they didn't.
After it was all changed and working I read somewhere that someone else had the same problem and found bad solder joints on the circuit board.
I ride a 2015 RTSE6. Mine had the same problem, fuel and temp gouges worked when they wanted. Replaced both gauges and still had problems. Finally took it to the dealership. They couldn't find a...
I am in Southern N.H.
I had to have the dash replaced on my 2015 RTSE6.
After replacing the dealer has to go thru a few steps to reset the air ride.
Location
Thank you Mike.
That is a 4 hour ride. I was looking for someone a little closer.
I am looking for someone near Southern New Hampshire or Vermont that can turn off the DESS on a 2015 RTSE6. Thank You
I have a 2015 RTSE6. Could someone please post the part numbers for the new Front Pulley and bolt. And the torque specifications for the bolt. Thank You in advance.
I have a 2015 RTSE6. I have the red dust . About 8,000 miles.
Could someone please post the part numbers for both the new white front sprocket and bolt. Also the torque spec on the bolt. Thank You...
187591
They are allen head bolts not torx
I had the same problem. I have a 2015 RTSE6.
The dealer had to change my entire dash.
Yes I did
I purchased a set of air vents for my 2015 Spyder RTSE6
They didn't come with directions on how to install. Is there anyone that could send me a copy.
Thank you
Message sent
Are you using an Allen wrench or Allen Socket?
I have found that a good quality Allen socket with a square end works best.
I know this is an old Post but are the vents still for sale?
Get a good quality Allen socket. Heat up the head of the bolt.Insert the Allen socket into the head of the bolt. Tap it with a hammer then turn it out with a ratchet.