Search:

Type: Posts; User: Chupaca

Page 1 of 17 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    19
    Views
    252

    Congrats...

    Last thing for the ryde was a couple of glass cleanable fuel filters to use as an oil trap going to the air box or in my case to the throttle body (just in case)...:thumbup:
  2. Thread: Vander Hall

    by Chupaca
    Replies
    22
    Views
    385

    They are nice.....

    Here's my choice...

    175734
  3. Thread: Any Idea

    by Chupaca
    Replies
    9
    Views
    279

    Interesting....🤔

    Being that small and looking like a cover with that lift tap, I would check under carpet for drain holes or access to lights etc....then again could have just been left there ...:dontknow:
  4. Thread: Recall???

    by Chupaca
    Replies
    6
    Views
    414

    Good to know

    :agree:Thanks for the heads up...:bowdown: Always good to have some advanced warning and not be surprised....:thumbup:
  5. Replies
    20
    Views
    611

    Yikes!!

    Run away from that dealer...:yikes: Have the kuhmo tire installed and enjoy your ryde. Many here are on that tire with no issues...:thumbup:
  6. Replies
    10
    Views
    425

    Review: choices, choices

    If you have in mind to trade now it will only get to be more what you want to do. Once you start thinking about it ..... well that's it..;) Now as to what to go with... With the pricing of the new...
  7. Replies
    3
    Views
    189

    Hang in there....

    By the time our RS's kick the bucket there will be more models to choose from....:roflblack: My 2012 RS and I are on an even keel as to who lasts the longest...:roflblack:
  8. Replies
    20
    Views
    1,002

    Interesting....🤔

    Quite an array of products mentioned for removal and installation. I have found over the years of changing grips on dirt, road, watercraft and atv's the best to remove is using a compressor and a...
  9. Defective....

    From what has been said here it is looking more like an injection problem at production of the plastic part. May be in a particular lot may be random. Something to watch for and see if there are more...
  10. Replies
    9
    Views
    197

    Just a bit more....

    As mentioned above, give the engine a bit more time to circulate the oil. Clutch plates can do this depending on how hot the engine was when last shut down and how much oil drained away and how fast....
  11. That's the way it is....

    My understanding is that if not set then the alarm goes off. Regardless of being in gear or not without the park brake set the unit will roll. Now the alarm will quit after 30 seconds or so. Once it...
  12. Replies
    2
    Views
    107

    Interesting....🤔

    I would think they do as I don't believe there was every any frame changes made.... You could get in touch with the manufacturer and see. I checked Shad online but they did not list Spyders. ebay has...
  13. For sure....

    Many have gone that route and it does work , for me, very well with a bit more pep in her step. Now to consider is the added sound from the air flow to the throttle body. There is a foam overlay that...
  14. Replies
    14
    Views
    443

    Oh yeah..!!

    Fun gadget and many have them but don't know if it is worth it. Not that hard to check the old fashion way and less tempting to take ones eyes off the road to see if your pressure is off...jmo like I...
  15. Replies
    8
    Views
    259

    Interesting...🤔

    seeing that the reach is so short it could only be used for bottom and/or top pinning. Possibly for drilling and attaching fender well and such...:dontknow:
  16. Replies
    26
    Views
    474

    currently black pants with light grey and red...

    currently black pants with light grey and red with reflection top....will next get the hi viz....
  17. Thread: Paint or Wrap?

    by Chupaca
    Replies
    6
    Views
    285

    Poll: Here's the thing..

    You can get a custom wrap though there are many to choose from. The advantage is that you can remove the wrap as you can with the plasti-dip paints and no harm done. Many potencial buyers in the...
  18. Replies
    25
    Views
    754

    It's a chore....

    Can get costly to find the right combination of handling, comfort and performance. I would venture to say the main ones being comfort and handling. Noise being one for the comfort side. It is a...
  19. Replies
    8
    Views
    209

    How often.....

    How often do you check the oil on your ryde...?? you should after a long ryde or about every 500 miles. I ryde hard and run usually most of the time between 6 and 8 thousand rpms and the weather is...
  20. Replies
    23
    Views
    654

    Here's the thing..

    Though at the time I know of nowhere you will get in trouble for removing the cat on motorcycles , if they came with one, this may become an issue in the future. I have been to many events and seen...
  21. Thread: Oil leak

    by Chupaca
    Replies
    3
    Views
    207

    Oil leaks.....

    Oil leaks are hard to pin point once it has run out and gotten wind blown around the engine. Back in the day we would clean the engine or area in question and spray it with Arid extra dry that dries...
  22. Thread: 2020 f3-s

    by Chupaca
    Replies
    12
    Views
    504

    1330cc: Really😲

    Glad to hear they are making a manual once again. Really hate to see that feature disappear. My daughter and I have to search high and low to get a manual car these days :banghead:
  23. Replies
    4
    Views
    219

    Interesting....🤔

    Wonder what the Harley crowd with the straight pipes do to keep from going deaf....:roflblack: The triple has been said to be noisey and though most work on hydraulics they do sound like there are...
  24. Replies
    37
    Views
    1,544

    Thanks .....

    Thanks for the link saw it last night . Now we wait and see the reaction from the members of the three wheel world out there....The electrics can be interesting....:spyder:
  25. Replies
    15
    Views
    731

    Interesting....🤔

    :agree: with spyderAnn, they have toyed with the idea for some time and shown us some nice concept but the chances are better now that so many are getting into the electric business....:dontknow:
  26. Replies
    24
    Views
    582

    Bummer.....

    The link is not working for me....:mad: should be able to find it easy enough...thanks for letting us know the stuff is up there anyway....:bowdown:
  27. Replies
    8
    Views
    627

    Yikes...!!!

    Let me know when she gets to southern California....:roflblack:
  28. Replies
    4
    Views
    275

    How are those tee shirts holding up...!!

    Nosing around the net I see that ELIO has projeted production for next month October 2019 and they plan to double their production....🤔 Makes you wonder as double nothing you still have...
  29. Replies
    22
    Views
    931

    Bummer.....

    11pm I can do but here that would be 2am and Im not doing that for a rainbow of color changes....:roflblack: Who knows could be more....:dontknow:
  30. Replies
    2
    Views
    82

    Oh yeah !!!

    Have seen quite a few around. Don't know if they are still available and not sure of the manufacturer. I know spydergirl, if still around here, had that faring on her GS/RS. Maybe it was Corbin who...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4