Search:

Type: Posts; User: AeroPilot

Page 1 of 17 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    9
    Views
    398

    All liquid storage tanks including gas tanks...

    All liquid storage tanks including gas tanks allow for "head space" for expansion with changes in temperature. Don't count on the last gallon of capacity especially on the RTs since their fill...
  2. Parade duty 173794in Florence Colorado. Also...

    Parade duty 173794in Florence Colorado. Also had a blue RT
  3. Replies
    24
    Views
    873

    Likewise at moderate speeds with a...

    Likewise at moderate speeds with a tailwind,,,,never at 75 mph.
  4. Replies
    17
    Views
    823

    Glad it worked for you! Safe Ryding!!

    Glad it worked for you! Safe Ryding!!
  5. Replies
    5
    Views
    332

    Spydies typically have a 3.5 amp fuse on their...

    Spydies typically have a 3.5 amp fuse on their 12V outlets - the compressors use about 6-10 amps depending on model. I recommend using a SAE plug wire set to the battery, and change out the lower...
  6. Replies
    42
    Views
    7,741

    Changed three HCM filters so far - No BUDS required

    Its easiest to just wait until your next 9300 mile or 15,000 km oil change and when you have a little extra time to walk through it but its easy especially if you have the ball head metric allen head...
  7. Replies
    17
    Views
    823

    I read about a fix that spreads the internal...

    I read about a fix that spreads the internal battery contacts and allows better charging while installed - It worked for my 590 LM
    ...
  8. Thread: Add oil

    by AeroPilot
    Replies
    15
    Views
    664

    If you have not rode the bike for 10 miles and...

    If you have not rode the bike for 10 miles and then let it idle for 10 minutes before shutting it down and checking the oil, you might not need oil.

    But straight after you do, use a narrow...
  9. The 47 # on the hitch will be loading he hitch...

    The 47 # on the hitch will be loading he hitch and forcing down the rear wheel a little more.... the no air in the air bag will be compressing the spring around your rear shock and bottoming out...
  10. Rear lift point is on the 4" main frame member. ...

    Rear lift point is on the 4" main frame member. I use a square of rubber tread to keep the jack from slipping off of the flat metal frame. As far as removing the GPS mount, it should be...
  11. Replies
    27
    Views
    1,783

    Like Ron and others have said the newer designs...

    Like Ron and others have said the newer designs require us to learn new ways to check oil. I am impressed with the efficiency of Rotax engines and I have seen a variety of oil levels when I tried to...
  12. Replies
    18
    Views
    826

    Thanks hOgr1der and I did edit my previous post...

    Thanks hOgr1der and I did edit my previous post as after rethinking it and measuring my sensor clearance, I agree with you. My current clearance from sensor to toothed ring is .96 mm and I will need...
  13. Replies
    18
    Views
    826

    "This moves the sensor ring closer to the sensor....

    "This moves the sensor ring closer to the sensor. " It will also move the sensor ring with relation to the sensor ifyou swapped spacers or bearings and then ...you are right It would be good to...
  14. Replies
    18
    Views
    826

    Since the centraMatic disk is behind the disk and...

    Since the centraMatic disk is behind the disk and sensor ring, its relation to the caliper arm and the sensor which is mounted on the arm is still Okay... It just moves the wheel to the left...
  15. Makes sense and great detail and diagrams to show...

    Makes sense and great detail and diagrams to show how the bearings come to rest with the inner race on the spacer... I do have a set of replacement bearings on the shelf, but so far haven't had...
  16. Replies
    3
    Views
    282

    http://www.lamonstergarage.com/lamonster-rt-ultra-...

    http://www.lamonstergarage.com/lamonster-rt-ultra-bright-led-fog-lights/ Google replace Spyder RT headlight and get the background on the installation.
  17. 172618 Maybe if you post a pic of where you're...

    172618 Maybe if you post a pic of where you're trying to clean it will all become clear. The Frunk Lip is accessible when you open the lid... to clean around the grille area, just remove the 4...
  18. Replies
    22
    Views
    639

    I would run until this winter and change before I...

    I would run until this winter and change before I put it up, unless I reach the suggested Oil Change interval miles... JMO
  19. Thanks ddjim, I did dump the cushdrive segments...

    Thanks ddjim, I did dump the cushdrive segments out and didnt see much in the way of grit or damage, just a few black specks but I didnt think of a little silicon grease. Might try it next...
  20. Replies
    3
    Views
    226

    Rob, I'm not a big fan of the traffic on...

    Rob, I'm not a big fan of the traffic on I-25 from Colorado Springs north to Cheyenne and prefer to ride the state routes when we can. You mentioned you were trailering, but speed limits are...
  21. Replies
    14
    Views
    529

    I too cringe at the first clunk of the ride after...

    I too cringe at the first clunk of the ride after starting my RT. While it is the "nature of the beast" I occasionally can avoid the WHAM by hitting the shift paddle within the first 1/2 second of...
  22. F3T squeal noise under load wheeling around or turning a corner?

    Squealing noise under load from F3T

    Our 2016 F3T has been a very dependable ride with few issues, but we have a sporadic squeal that sometimes occurs under load like accelerating through a turn in...
  23. Replies
    12
    Views
    609

    Like 2 Dogs said the FOBOs shouldnt cause the...

    Like 2 Dogs said the FOBOs shouldnt cause the shake. Since your bike was setting all winter, I bet the tires had a little flat spot issues for awhile... then when you rode it a bit the tires...
  24. Replies
    8
    Views
    420

    " Also ... you are not supposed to touch your...

    " Also ... you are not supposed to touch your bell unless it is attached to your trike/bike."

    Its always good to practice safe mechanican and wear gloves.....;)
  25. Replies
    7
    Views
    484

    I dont remember any issues with mounting the side...

    I dont remember any issues with mounting the side mount drink holder on the 16 F3T. It is much more stable now on the frame and easy to access.

    172207 With the IPS frame caps it looks and...
  26. Replies
    17
    Views
    674

    172153 or a paint can lid lifter works well; ...

    172153 or a paint can lid lifter works well; especially if polished with a sander on the curve so it levers the pin out smoothly
  27. 172121 Had about 6 oz of RIDEON in my front...

    172121 Had about 6 oz of RIDEON in my front Kenda when I had a puncture...It didnt seal by itself, but after I added the mushroom plug from my StopnGo kit it held with no leaks for another 5000...
  28. Physics always works if you can quantify the...

    Physics always works if you can quantify the inputs and measure the resulting changes including all energy. The rear wheel will always build more heat and therefore pressure than the front tires...
  29. Replies
    53
    Views
    2,144

    I agree it takes a bit more to become comfortable...

    I agree it takes a bit more to become comfortable with the variety of road conditions, crown, ruts etc than with the gyroscopic motion of two wheels tracking a single path. For me it helped to have...
  30. Replies
    7
    Views
    452

    Hopefully you have a good shop and they properly...

    Hopefully you have a good shop and they properly condition new batteries like Idaho said. I think your battery on the 12 model is a little bit of a chore to get to...I trusted our shop to change it...
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4