LS2 Variant 2. Fully modular. good breathability in hot Florida summers
Type: Posts; User: RUKNOT
LS2 Variant 2. Fully modular. good breathability in hot Florida summers
Wow, now I feel stupid. Just did that. It didn't say new key, but after doing both keys. it works past 2 minutes now. Should I still recommend swap the 02 sensors back to stock?
Thank you very much!
Now that you mention the key situation, I did install a new key system with new DESS. After each start it shows "New Key"
200971200972200973
Good morning! Thanks for a fast reply. I didn't find the power commander. there was a wire going to the 02 sensor which went to this box which i assume is the wideband controller. The bike ran first...
So one of my buddies just bought a 2013 CAN-AM RT Limited from a women that had it from her husband. he just asked me to check out a problem where the bike would shut off on low rpms and would not...
It would be different for the before 2013 and after 2013 model, but this is what it looks like on a 2018 when the frunk is completely removed.
200951
Has anyone put the ICSI brake on the 2020 model year? One of my buddies wants to put one on. Is it expensive to install? is it even possible?
thx for the reply, but I have a just metal key. No chip. So it wont work, new dess system incoming.
Does anyone else hate the buds2 design? The BUDS for 2014 and down was so simple and intuitive, the new one is like going through a jungle where every plant is poisonous. Also, does anybody else know...
The problem is that i have a 2013 CAN-AM, and can not disable Dess. It has a metallic key, no chip. And I wanted to program a new key. Didn't work out, should have done more research. Bought new key...
Merry Christmas spyder lovers! I am looking to buy blank master keys for the spyders, is you have a lot of them, I can buy in bulk. You have 1? I'll buy it. Post your offers, I really need...
If you can help us figure out what you need, i can probably order a new one for you with a discount
If anyone needs help with programing a new key in South Florida. I can help
High strength aluminum 11 gal (42 L) removable
top case
with two USB, two 12V power outlets
High strength aluminum 19.5 gal (74 L) removable
side cases (optional)
Auxiliary power: two 12V and...
GIVI TREKKER OUTBACK saddlebags taken off a CAN-AM Spyder F3-P(yes P, it was a police model) with the installation bracket. Asking $1200 for the full kit, new would be around $2300. I'm located in...
Stripped the bike, the left control switch randomly decided to start working again, the p brake is still dead
The problem is that I cant find the PBM, on the RT Model it is located with the windshield motor. On the ST model it is a separate module which I cant find. My suspicion since it died with the left...
No, the P switch is in the center console. They just both died at the same time
Hi guys, I have a 2014 Can-Am Spyder ST -S that I've got a problem with. The left housing switch doesn't work some of the time, and the parking brake stopped working completely. I've tested the...
So since this is 2011
1. CHeck that BOTH of the positive wires are connected to the battery.
2. Check the 60 amp fuse that goes to the front, it is under the LH side panel
3. check battery...