Printable View
So, Last week, I finally installed my BRP heated grips onto the bike since I was doing some other wiring mods inside the guts. All was crystal clear and easy except the part where you had to remove the 4 little allen head screws from the bottom of the handle bar covers. Not really mentioned in the instructions or the factory manual. Unless i missed an important step, they were dang near impossible to remove without a whole lot of cuss words even I did not know.
Good work, guys................
Never underestimate the power of verbal motivation!
Did you rotate the handlebars ?
Products are typically designed for assembly, not disassembly.
Looks like they have you covered.
I tried so many ways I can’t remember all of them. The most difficult part was trying to get them back into the holes to tighten them back up. My fat fingers keep losing grip on the Allen wrench and then it and the bolt would start falling out. Almost had 2 disappear into the dark depths of the Spyder. Anyway, hope I never have to do it again.Quote:
Originally Posted by ThreeWheels
Quote:
Originally Posted by Grandpot
You called that one right on!
The absolute worst tool for installing socket head bolts is an allen key. This particular installation is much easier with a hex drive socket on a 1/4 drive twist handle ratchet.