2019 F3L. 6000 miles, purchased 3/2020
Checked and replaced my front pulley today, discovered rust starting on splines....no real trace of assembly lube.....glad I checked it!:yes:
Look at last sentence....from 2020 F3 &RT updates
Printable View
2019 F3L. 6000 miles, purchased 3/2020
Checked and replaced my front pulley today, discovered rust starting on splines....no real trace of assembly lube.....glad I checked it!:yes:
Look at last sentence....from 2020 F3 &RT updates
Did you run your rag in the spline bore and see the paste wipe away. Pretty sure there is a slight trace on the splines ends. It looks like white grease.
True spline lube does a better job, and yes, I know Kluber recommends that stuff for splines, but must be for low loads since it simply does not hold up.
Any decent moly lube paste will work well. Some have recommended pastes with a high percentage. My opinion is you should be fine with brand name products containing a reasonable amount of moly.
I used Honda Assembly Paste......it seems like good stuff.Quote:
Originally Posted by PMK
Honda stuff is relabeled MolyKote. I think #77, same as what Honda calls it.Quote:
Originally Posted by bikerchris1270
Yes, a very good product for lubricating drive splines.
Like engine oil, spline lube does not last forever. Since the task is not difficult, I suggest you check the condition at around 14,000 miles then at the 28,000 heavy maintenance event. You may find the point of how frequently to relube vs how many miles per year you ride.
You were smart to do the inspection and proper lube well before any external indicators of wear show up. Essentially by the time red dust appears externally, the pulley is trashed, and possibly the shaft splines are worn also. Fretting is a serious destructive wear type corrosion, seldom seen or understood except by persons with experience seeing, inspection repairing and maintaining assemblies where it occurrs.