SpiderGreg's Mods

Just noticed this area on the forum so moving my signature data to here.

2012 RTS purchased Aug 29 2015 with 920 miles on it.

http://www.spyderlovers.com/forums/a...d=121269&stc=1

Since we purchased the Spyder...
WGT LED Turn Wraps
Two Brothers Exhaust
Zumo 665 w/GXM40
RBNS Hood for GPS
F4 Customs Oversized Tinted Windshield with Vent
SmoothSpyder Tensioner/Beltguard

BajaRon Sway Bar w/Billet Aluminum Heim Joints

Chrome LidLox
Air Hawk 2
TricLed Fender LED's
Sena SMH10
His and Her's Cup Holders
NVB Highway Pegs
XenonDepot LED Headlamp and Foglamp bulbs
SpyderPops Skid Plate with LED's
Two Vanity mirrors, one inside truck lid and one inside trunk
Convex blind spot mirrors
Battery Tender
Cargo Netting inside of trunk and saddle bags
Travel bags for the saddle bags
BRP Air Scoops
Custom Dynamics HMSL
4 JBL 528s Speakers
BRP Comfort Seat
Elka Stage 1 Shocks
Laser Alignment
And of course a Spyder Decal

Looks Terrific! You didn't waste any time farkling!
Love the blue color
Now put some miles on it and enjoy:D
Thanks for sharing

well done...:2thumbs: looks sharp so now you need some R&R..... rest and ryde...:ohyea::ohyea:

Thanks for the comments! After we picked up the Spyder, I joined SpyderLovers shortly after and started reading through some of the best Farkle's and just started in! This site is great for suggestions and knowing what needs to be done in just about any situation. And this site gave me the confidence to install all of the Farkles myself. This is a great site! We haven't taken it on a trip as of yet, but we now have close to 3,000 on her and looking to make an appointment for the 3,000 mile check up.

How hard was it to install bumpskid, from Spyder pops?

Quote:

---

Originally Posted by Larry rt

How hard was it to install bumpskid, from Spyder pops?

---

The bump skid was quite easy. Took less than an hour. Need to put the front of the Spyder up on some ramps so you have some room to move around under the front of the bike. The SpyderPops instructions were very good with clear directions. Take the existing bump skid off, then you place two "J" clips inside of the tupperware (this was the actual hardest part flexing the tupperware such that you can get to first two "J" clips in the proper location) and then screw on the SpyderPops bump skid with the two long screws. Using the bump skid itself as the template you then drill several hole in the bottom of the tupperware and two holes though the frame supports. Remove the bump skid and install "J" clips in all of the newly drilled holes, then reinstall the bumpskid in its final position. Run the wire up the A frame and it simply plugs between an existing connector for the running lights on the fenders. Everything you need to install is provided in the SpyderPops kit. Take you time and you will be fine!

Tanks for info! :bowdown::bowdown::2thumbs: