Skid Plate for running boards

[Jimmy Neutron]

This may not be the right way but its the way I finally ended up with. We took a 1/4" plate of aluminum {Cant say or spell it} and fit tight up to frame. We then drill Holes in the middle of the frame. We then took off the foot pegs and dropped down aluminum blocks. Then we used a spyder pattern and cut out with plasma cutter. It looks pretty good and works awesome. I am finally happy with my footrest..

[bjt]

Like they say, a picture is worth a thousand words... :D

How about a pic bro? :nopic:

[Jimmy Neutron]

I will I have no idea how to get pic on I am computer dumb..

[Rando]

If you email to me, I will post it for you.

[Jimmy Neutron]

Send me your email or phone number and I will do that Thanks Man

[Rando]

email address sent, check your PM (private messages)

[Rando]

Here are the photos. I envy those of you with the SE5 that can do this and not have to worry about the shifter. Nice job!

[Jimmy Neutron]

Yes and thanks so much for your help.. They work great and The are very sturdy.

[Roaddog2]

I will I have no idea how to get pic on I am computer dumb..Me 2 Me 2:2thumbs:

[Lamonster]

I will I have no idea how to get pic on I am computer dumb..
http://www.spyderlovers.com/forums/showthread.php?t=8044 :doorag:

[Jimmy Neutron]

I did see that Lamonster and I will try to figure that out Thanks. I think Im hopeless.

[NancysToy]

...I think Im hopeless.
My wife says that about me...........a lot! :D
-Scotty