Gear Position Sensor - non-plastic

[jwulf74]

So...I don't have the equipment to produce these, but after having both of our gear position sensors replaced, and seeing several others having to do the same, and finding out that pretty much all the Can Am stuff uses the same part...

I think it would be great if one of our vendors could produce the little plastic part with the D in it in metal... that is the part that wears down and breaks...

[ThreeWheels]

I'm not familiar with this part, nor did I stay in a Holiday Inn Express.

In general, making a part stronger sounds like a great idea.
I have one question. What does this part contact ?
Might you just be transferring the wear issue to the next part either up or down-stream in the train ?

[Bob Denman]

:agree: sort of...
Heat transfer could become a problem, but parts diagram could really help to sort some of this out! :thumbup: