KURYAKYN & Passenger Peg Test Fit

[powerbyaj]

Looking at different solution for drop passenger pegs. I do not have access to Kuryakyn products so i cannot test the fit. Can someone test the fit on two products and give me feedback. The adapter for the peg would be used without the ball and spring setup.

Kuryakyn 7937 4" Drop bracket or 2" Drop bracket {replace HD mount with mounts below}
Kuryakyn 8818 Rear Splined Adapter Mounts
Kuryakyn 8808 Front Splined Adapter Mounts

1130

Kuryakyn 8818 Rear Splined Adapter Mounts
1131

Kuryakyn 8808 Front Splined Adapter Mounts
1132

Thanks

[Lowflyingowl]

I believe it was the 8808 that i tried this solution with -- no deal.

The Kury mounts are totally loose.

I'm waiting a few days to check out NMN's new passenger peg adapters -- then your solution may work since I believe you'll be able to use the Kury drop with them.

I'll have to cost out this option versus TJ's solution. His sure look more in keeping with the Spyder's powder finish instead of Kury's chrome, so I might go with his anyway.

[LDFIREWORKS]

i have nmn and they work great:clap::2thumbs:

[tatt2r]

i have nmn and they work great:clap::2thumbs:

I've use both mnm are better

[powerbyaj]

i have nmn and they work great:clap::2thumbs:

I do not see any passenger drop pegs on NMN site. Can someone point me in the right direction:

[Lowflyingowl]

NMN hasn't updated the site with them yet -- they were down at Daytona and just had the parts ready before then. I expect to see them listed on the site by the end of the month.

Also check out the post from Lamonster today with BRP's passenger pegs...