PDA

View Full Version : 12v outlet


steriltech
11-21-2015, 03:19 PM
Hi all I have a 2012 spyder RT want to put a 12v outlet but were can I put one??? I have one in the trunk... Could you send me some pics to give me an idea:yikes: Thanks All!!!!
Bfromla
11-21-2015, 06:46 PM
Rear trunk or frunk? Should be area ready in frunk fyi my frunk liner kinda in way120108 heres one with flap up & flashlight plugged in120109 when in front of bike looking in its about 1/2way up the back wall on RH side. G'luck


Sent from my iPhone using Tapatalk
IGETAROUND
11-21-2015, 06:47 PM
​check Finless videos
armyspydervet
11-21-2015, 07:24 PM
USB
Bensonoid
11-21-2015, 07:55 PM
If you don't have gauges.
Highwayman2013
11-21-2015, 07:56 PM
Speaker grille.
Mazo EMS2
11-21-2015, 08:07 PM
Another vote for either one of the speaker grilles. Easy access. Pull one out and check it out
vided
11-21-2015, 08:16 PM
left speaker grill

http://www.spyderlovers.com/forums/attachment.php?attachmentid=120120&stc=1
http://www.spyderlovers.com/forums/attachment.php?attachmentid=120121&stc=1
finless
11-21-2015, 08:17 PM
Speaker grill...


https://www.youtube.com/watch?v=cOTwhpdFq4Q
robmorg
11-21-2015, 08:27 PM
I mounted a weatherproof 12v outlet from Battery Tender on JT's accessory bar on top of the glare shield. Keeps the wires out of the way and easily accessible for charging my phone, also mounted there. I keep a duel USB charger inserted in it.

https://lh3.googleusercontent.com/-oO8Nr1RRvMY/Vamst28uZzI/AAAAAAAAAe4/YV64BanMdTI/s912-Ic42/scoop_cockpit.jpg
GeoffCee
11-21-2015, 09:51 PM
On the left side of my 2011 RT just inboard of the left passenger grab handle I found a mounting blank already moulded into the plastic. it was a simple job to press out the blank and install a power outlet fused to 10 amps for my wife's electrically heated vest. The socket is very convenient in this position to supply 12 volts to the vest. The aim was to keep the wire to the vest as short as possible. if i needed an electrical supply for a different purpose I would obviously mount the supply socket close to where it was needed, I would hate to have exposed or trailing wires running around my Spyder. BRP made a good looking machine, it's not my job to turn it into a cluttered-looking mess.
jthornton
11-22-2015, 07:13 AM
You could mount it on the dash or in place of a gauge.


Oh the bezels are satin black now...

JT
steriltech
11-22-2015, 03:58 PM
were did you get that use????????😊
jthornton
11-22-2015, 04:01 PM
were did you get that usb????????😊

I make the mounts and sell them in my Spyder Store (http://gnipsel.com/spyderstore/).

JT