How far out?

[Cognac]

When you had the laser alignment done, how far out was your alignment?

[GOZFST]

Don't remember the numbers, but it was way out and the jam nuts were loose.

[cuznjohn]

mine was less then a half inch, but i don't remember what side was really off

[STELLING MAN]

My left tire was out 5/8 In. and the right was out 7/16, Lamont did mine while I was at Spyder Fest,,

[shakey]

I was told mine was out 1 1/2" on both sides.

[Devious56]

Mine was 1 3/4 inches, in on one side and out on the other. Mike Loescher of Spyder Comfort did mine and said it had a lifetime guarantee.

David

[Bob Denman]

I don't remember the numbers... :opps:
But Ron Netzley aligned mine, and he said that it was "almost" close enough to not need much tinkering...
But one side was toed-out further than the other.

[Chupaca]

don't remember the figures. Squared Away did it both times but the second does confirm that messing with the rear wheel, changing shocks and front tires does mess with the alignment...:thumbup:

[JayBros]

Close counts only in horseshoes and hand grenades!

[SpyderAnn01]

Close counts only in horseshoes and hand grenades!

And Field Artillery too. :yikes:

[Cruzr Joe]

Mine was Laser Aligned by Lamont when it came off the Showroom floor at PitBull PowerSports and i had it checked at 7500 miles and it was still good.


Cruzr Joe

[SpyderAnn01]

Mine is still going straight after 61,000 miles.

[pauly1]

On three Spyders, all were toe-out by about 1/8" in 6' - going to slight toe-in fixed tire wear and greatly improved the handling. The shop manuals state the measurement is +/- 3' from axle center line. The LASER alignment systems are a much greater distance (11 to 12'), which translates into higher possible precision.

I did our RS and ST; Mike Loescher, the LASER system inventor, did my F3 at the Deadwood Three Wheel Rally in Aug. The discussion I had with him about steering and alignment was worth more that the wheel alignment.:bowdown:

Wayne

[Bfromla]

Mine was bout 1/2"in on both sides. Tracked good I thought glad I had done & will make yearly thing. Too bad no one local but more reason to spyderfest:thumbup::roflblack:

[beadaholic]

I don't think we have laser alignment here, wish we did though, not sure what can be done about alignment here in Mexico? Go to a car joint? or ?? :banghead:

[cptjam]

I don't think we have laser alignment here, wish we did though, not sure what can be done about alignment here in Mexico? Go to a car joint? or ?? :banghead:
Come on up - we can Square You Away! I doubt car equipment would work properly. Las Vegas is not too far, and as good as an excuse as any to visit our little city! Joe

[pman]

Mine was out 1 1\4 inch. Had it done at Maximum Motorsports in Peru, IN. Was amazed at the differance it made.