Spyder Lifts or jacks?

[thereverend]

What is recommended to lift the 2014 RT Limited front end up to about 20 inches?;) , as I am going to attempt to install Ron's sway bar...

[aeroshots]

I used a pair of these.

http://www.amazon.com/RhinoGear-11909-RhinoRamps-Vehicle-Capacity/dp/B006EGAIII/ref=sr_1_4?ie=UTF8&qid=1429288413&sr=8-4&keywords=plastic+ramp

For the rear two holes it was necessary to lift it another inch using a standard floor jack.

[Chupaca]

on what you have to work with. You can raise her a bit at a time one side then the other with a regular jack (bottle or sissor) and "A" stands. If your going to invest in one there are several available. The atv/motorcycle lift works well. Heres what I use...http://www.spyderlovers.com/forums/attachment.php?attachmentid=105653&stc=1 http://www.spyderlovers.com/forums/attachment.php?attachmentid=105654&stc=1

[Ex-Rocket]

What is recommended to lift the 2014 RT Limited front end up to about 20 inches?;) , as I am going to attempt to install Ron's sway bar...


I installed the Baja Anti sway bar yesterday. I used car ramps to get under the bike to remove the panels that were necessary. But it wasn't high enough to get the old sway bar out or the new on in. So I used my motorcycle/atv lift to get it high enough. Good luck with your install. You will love the results though.